SOURCE: Immobiliser for 98 Ford Escort
read my posting and it will show you,,,this is for a petrol version if its a diesel get back to me for different instructions
SOURCE: how do I change my oil on my 98 ford escort zx2
Try this.
On level ground, jack up the front of the car and support it with axle stands.
Get an open container that will take more than 5 ltrs.
Under the engine block you will find the sump.
On the sump you should find a 13mm nut, this is the drain plug.
Undo the drain plug and have the empty container directly below the sump plug.
Retain the sump plug and clean it with a rag.
When the oil has drained out of the sump, put back the plug making sure the washer is in good condition and the plug is tight.
Now unscrew the oil filter having the old oil container below the filter housing to catch any oil.
Wipe around the the filter housing to remove any and all old oil.
Now offer up the new oil filter but do not tighten.
If the new filter fits the oil filter housing, then remove it and lightly oil the rubber seal on the filter with clean oil.
Now refit the filter and tighten it up. Not too tight, you can do this by hand but get it as tight as you can.
Now lower the car to to the ground.
At the top of the engine you will find an oil filler cap. Undo this cap.
Now put in the new oil to just below the full mark on the dip stick. Let the oil drain through the engine to the sump for a couple of minutes before checking the oil level.
If the level is between 1/2 and full, replace the filler cap and start the engine.
Now look at the oil filter and the sump plug for any leaks. Also check around the oil filler cap for oil leaks and spillage.
With the engine turned off. Clean any oil spillages and tighten up the oil filter, sump and oil filler cap as required.
Now leave the oil to drain back to the sump for a few minutes.
Check the oil level and top up as required.
I find that it is best to top the oil up to just below the Max mark.
This should solve the problem.
Ray
SOURCE: 98 ford explorer oil pressure sensor location
2.9L and 4.0L engines-Left side front of the engine, below the cylinder head in the engine block
SOURCE: how to install a coolant temp sensor in a 1995 ford escort
The coolant temperature switch and fan control switch are located sie by side, mounted in the steel portion of the heater hose that runs from the thermostat housing to the firewall, it is underneath the air intake tube and the ignition coil pack, mounted to the back of the cylinder head. Either drain out some coolant or be very quick, and you can unplug and unscrew each switch from the hose and replace it with a new one. Make sure the engine is cold. After replacing make sure to check the coolant level add as neccessary. The single wire connector switch is for the guage, and the other is for fan control. Hope this helps, let me know.
SOURCE: 98 FORD ESCORT ZX2
1998 ford escort sport engine started making a tapping noise and engine light started flashing. Had oil and water at normal level.
Car has 110,000 miles. Been serviced regularly!
37 views
Usually answered in minutes!
×