SOURCE: Low / Soft Clutch Pedal, 1995 Rodeo 2W 2.6L
my rodeo had the same problem i corrected it by bleeding the slave cylinder. and is located on the driver side on the gearbox you will find it if you follow the line from the master cylinder down to the gearbox and if that helps but happens again it might have to be replaced.
SOURCE: Clutch pedal sometimes engages when near floor
Hi. Let me try to lend you a bit of assistance, also.
My fellow expert Benimur is very correct with his input to you.
But...Air does not get into your clutch hydraulics unless the fluid has leaked out at some point. As long as the cylinders and tubes are intact, I would doubt that air is the issue. Short of pulling the transaxle, and inspecting the clutch, there is really no other way to determine your issue properly.
Personally, I think that you haven internal problem with the clutch assembly. It could be worn fingers on the clutch plate, a worn clutch disc, or something as simple as the throwout bearing is hanging up on the input shaft collar.
If Beni's suggestions does not help, you are going to need to pull the trans off, and inspect the clutch items mentioned above.
Thanks for choosing FIxYa, we wish you the best of luck; let us know how it turns out.
SOURCE: 1997 hyandai accent gt clutch problem
hi considering age of car and that you have no leaks on hydraulics? may i suggest you try bleeding the clutch to rid of old fluid a couple of pumps may be suffice ? b/fluid does absorb moisture and heat over time hence recommendation tat fluid be changed at period specified in handbooks ie 12 monthly ?
157 views
Usually answered in minutes!
×