2006 honda odyssey vsa,abs check brake lights on, but no dash speedo etc

SOURCE: 2003 Honda Odyssey Brake light replacement

open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).

SOURCE: How to change the cabin filter on 2006 Honda Odyssey?

I will never understand why this service is so expensive at the dealership.
I made a video showing how this is done:   (I would recommend watching the video in HQ and full screen)

SOURCE: My Honda Element 2008 has a VSA Warning light and

It may be as simple as your oil condition or oil level. If you have poor oil in your engine the VTEC system will not operate properly and when RPMs reach 2800 or so it will buck. If everything checks okay with the oil have the code checked for your check engine light/VSA light.

SOURCE: 205 honda crv, vsa, abs, and triangle lights are

check your warrentry y could be covered

SOURCE: 2006 Honda crv, vsa, abs, and triangle light are

You are talking about the VSA activation indicator (triangle with exclamation point in the middle):
This indicator has three functions:

It comes on as a reminder that you have turned off the vehicle stability assist (VSA) system.

It flashes when VSA is active.

It comes on along with the VSA system indicator (the rectangle with VSA in it) if there is a problem with the VSA system.

This indicator normally comes on for a few seconds when you turn the ignition switch to the ON (II) position, and when the ignition switch is turned to the START (III) position.

Hope this helps you understand the problem.