SOURCE: jeep wrangelr Crank Position Sensor
wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.
SOURCE: Jeep is giving a code of p0340 which is telling me
go to autozones website they have free diagrams
SOURCE: where is locate the camshaft position sensor on
The camshaft position sensor is located inside the distributor. It is a hall effect swich, simply remove the distributor cap and the rotor and you can lift it out, unplug and replace.
Have fun but beware a bad crankshaft position sensor can cause a false cam sensor code to be set sometimes.
Good luck.
SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee
If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)
SOURCE: where is the camshaft position sensor located on a
the camshaft position sensor is inside the distributor, the crank sensor is at rear of engine in bell housing above starter. see pic of sensor below
1,080 views
Usually answered in minutes!
×