Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button.
If you need more help email me at [email protected]
SOURCE: Ho to reset oil ligth for bmw x5 2003
switch off ignition
press & hold button between speedo and fuel gage
turn ignition to pos I
after 5 seconds the word "oil service"or "inspection"are shown together with the message "reset"or "re"
release button on dash
press and hold button - after 5 sec the message "reset" starts to flash
release button - press and release button again
the new service interval is now displayed
press and release button
the message "end sia"is now displayed
switch off ignition
SOURCE: Reset oil light
Get in vehicle before turning key to 1st position, press in & hold odometor reset button while holding in turn key to position 1. after a few seconds reset will appear on screen release & push in again. it will ask you if you would like to reset, press again.
SOURCE: I just go locked out of my X5 BMW 2002 x5 and my
right i had this ***** of a problem 2nd week in jan 2010. a bmw mechanic told to jack car up at front and hook a jumper pack up to live on starter motor terminal and then earth, was quite hard to put croc clip on to starter but did manage it. this was supposed to back charge to battery to get enough power to open car with remote, in theory it should of worked but i gave up after 3 hours-no power. so i got my key put it in drivers door and mechanically turned to open position, then i got a cutlery knife from kitchen and wrapped some insulation tape around tip up 2-3 inches. then i pushed this down glass directly above door handle key end to pry a gap between glass and rubber just enough to slide coat hanger wire in with small hook on end then i manouvered wire hook until i hooked latch arm which i did within 1 minute pulled coathanger wire up and pulled door handle the door opened much to my delight. this was a major sigh of relief after trying for 2 days to get in, and many hours searching the net for a solution which i couldnt find. THIS WORKS 100 percent WITH ABSOLUTELY NO DAMAGE!!!!!!! any questions email me- [email protected]
SOURCE: how do I remove the
you need to look inside the trunk of your car pull back the carpet backen and you'll see what you are asking I thank.
SOURCE: My 2009 Toyota Highlander lift
Thanks for choosing FixYa and welcome to the site. You need to make sure that your fuse is not blown. Check your fuse box diagram for the location. If the fuse is fine, you may have a bad switch. There could be a loose wire or a bad connection to the switch.
12,946 views
Usually answered in minutes!
×