2000 Chevrolet Tracker Logo

Related Topics:

F
Frederick Johnson Posted on Oct 26, 2016

2000 chevy tracker 2.0L engine timing chain replaced still runs rough at idle good at highway speeds

New chains new sensor

5 Related Answers

Anonymous

  • 341 Answers
  • Posted on Nov 08, 2008

SOURCE: 1989 chevy 350 automatic, white smoke

white smoke is antifreeze try checking the compression

Ad

Anonymous

  • 1 Answer
  • Posted on Dec 10, 2008

SOURCE: 95 GMC Jimmy 4.3l W vin rough idle

My problem was solved when I repaired my 4 wd activation dash switch. The switch was contacting on 2WD & 4HI at the same time. The front differential activation is vacuum activated possibly creating a tug of war that didn't actually engage it but drained off vacuum from the engine? A theory at best but stumbbled across it because I knew the switch wasn't working properly I repaired it and low and behold rough idle disappeared and all is good for 3 weeks running.

Molson02536

Harvey N Tawatao

  • 3854 Answers
  • Posted on May 04, 2009

SOURCE: how to replace a timing chain 2000 chevy cavalier

I am familiar with that vehicle but generally with timing chain replacement, the engine needs full access for pulley and cover removal and in some cases the cylinder head requires removal.
Generally timing chains last so that they only need replacement at engine overhaul and it is not an economic proposition to have to replace a chain unless some relative degree of engine work is also required at that time. 

Engine timing chains generally have a tensioner on them which maintains tension, but some chains can wear significantly and cause timing cover to be "ground away" because of "slop".

If the engine is making the noisy rattle of the timing chain against the cover etc, I would schedule a top overhaul (head, machine, test and valve grind) with the chain replacement dependent on mileage with the degree of action.

Some simple simplex timing chains (type of chain similar to motor bike chain) may be replaced without dismantling the engines but I would expect your chain would be a "duplex" dual sprocket type, these are most common. 
These chains are not generally expensive but replacing them can involve a fair amount of work. 

Good Luck and hope this helps, Others will have different ideas.

Anonymous

  • 323 Answers
  • Posted on Jun 15, 2009

SOURCE: 88 chevy 350 knocking or pinging near front of engine

Just for the heck of it, have you tried upiing the gasoline one grade?

Anonymous

  • 2 Answers
  • Posted on Feb 12, 2012

SOURCE: 2002 chevy trailblazer has rough idle

There are numerous things that can caise a vehicle to idle rough. Could be a throttle posistioning sensor. pcv valve, dirty fuel filter, worn spark plugs and wires, possible O2 sensor. If the vehicle has not had a tune up yet, I would recomend one. Even if it doesn't fix your issue, the vehicle is ten years old and probably needs on anyways. Start there, then rule out the cheaper stuff next. pcv valve and fuel filter, inexpensive and it's probably time anyways. If you are getting an engine code, stop in to advance auto. They'll plug it in for free. If your still having problems, you may have to break down and tajke it to a mechanic to get plugged into a real diagnostics machine.(probably run you around $100)

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

I just replaced timing chains on my 5.4 24v engine now after about 30 mins of driving the engine struggles to run as if not running on all cyl at hwy speed ok but in stop start traffic not good

check the valve timing as it indicates a timing problem.
the higher rpm at highway speed indicates that the valve timing is coming correct as the rpm advances the timing in the solenoid actuation but at idle it is out a bit
could be one cam off a tooth
run the fault codes to see if the cam shaft advance operation is working ( wiring , cam shaft position sensor , actuator etc )
check the fuel pressure and injector operations as they may be failing at the lower pulse action
0helpful
1answer
2helpful
1answer

My 2000 chevy tracker wont start

if you have not changed the camshaft position sensor you need to do that sounds exactly like my problem got the new fuel pump and filter in there and it was fine for a month then same thing started happening again, been fine for 7 months since I changed my camshaft position sensor
0helpful
2answers

My chevy cavalier runs find at high speed but won't idle The mechanic said the timing chain needs replaced

You have a device called the idle air controller. This controls the idle speed. You can clean it out with spray carb cleaner. This may cure your problem. Also replace the PCV valve.
2helpful
1answer

How do you check and change a camshaft position

The camshaft sensor wouldn't explain the clattering noise. But a timing chain would explain both. Clattering from a loose chain and the camshaft sensor code from when the chain broke and the camshafts stopped turning.
2helpful
1answer

My 2001 Chevy Tracker quits running after a while and will restart after about 10-15 minutes. It originally runs rough after it restarts. I have been told to replace the camshaft sensor. Also, when I...

Had the same problem with my tracker. Replaced the camshaft position sensor(easy to do yourself, takes about five mins.) Now can drive at highway speeds for about a half hour and stop at the gas station and she'll start back up and run fine. Before i had to wait at least 15-20mins before she would start. Also, if your service engine soon light is on take it to the national chain auto parts stores and they will hook up the code reader for free. The sensor runs about $120.
0helpful
2answers

Tensioner on 2000 chevy tracker 2 litre

the plungr may be bad try a new one
1helpful
2answers

Lack of power and rough idle

Is your "check engine" or "service engine soon" light on? Lacking power is usually an emission system problem, for instance possibly a bad EGR valve or mass air flow senser. O2 sensers are common to fault but normally doesn't cause power loss usually causes alittle rough idle. Could even be a pluged catalic converter to. have the truck plugged into a scanner, that will tell you the trouble codes and fault info.
2helpful
1answer

95 GMC Jimmy 4.3l W vin rough idle

My problem was solved when I repaired my 4 wd activation dash switch. The switch was contacting on 2WD & 4HI at the same time. The front differential activation is vacuum activated possibly creating a tug of war that didn't actually engage it but drained off vacuum from the engine? A theory at best but stumbbled across it because I knew the switch wasn't working properly I repaired it and low and behold rough idle disappeared and all is good for 3 weeks running.
Not finding what you are looking for?

283 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...