Are all windows not working ? Two separate circuit breakers left & right . Both in rear fuse box .
Fuse Block - Rear Beneath the left rear seat
Check for broken wires inside the rubber boot from body to doors.
Do you know about electronic control modules ?
The power window system consists of the following components:
?€¢
Driver door module (DDM)
?€¢
Passenger door module (PDM)
?€¢
Body control module (BCM)
?€¢
LR power window switch
?€¢
RR power window switch
?€¢
Window up and window down relays in each of the rear passenger window switches
?€¢
Window lockout switch
?€¢
Reversible power window motors in each of the doors (circuit breaker protected)
?€¢
LT DOOR CB 25A (System power for left rear window)
?€¢
RT DOOR CB 25A (System power for right rear window)
The power window system will operate anytime the retained accessory power (RAP) system is active or when the ignition switch is in the ACCY or ON position.
The DDM contains 4 power window switches which are integral components. Closing any of the normally open, rocker type switches provides the DDM with a request for power window operation. The switches for the 2 front windows have 3 positions Up, Down and Express Down, while the switches for the rear windows have only 2 positions, Up and Down. Each of these switches and their positions is a direct input into the DDM. Upon receiving a request for power window operation, the DDM, transmits a class 2 message indicating the switch and it's changed position.
The PDM contains a single power window switch that is an integral component. Closing of this normally open, rocker switch provides the PDM with a request for the front passenger power window operation. The switch for the front passenger window has 2 positions Up and Down. Each of these switch positions is a direct input to the PDM.
The 2 rear passenger doors have there own switches. Each of the switches contain a power window up and down relay. A switch activation alone can control the up and down functions of the rear windows. However the BCM, upon receiving a class 2 message from the DDM, can control the set of relays which will activate the rear window motors.
Check
There are two fuse boxes/block
One fuse block is located under the hood in the engine
compartment on the driver's side of the vehicle.
Remove the primary cover by pressing the two locking
tabs. Remove the secondary cover by snapping off
while lifting. To reinstall the fuse panel cover, reverse
the sequence.
The 2nd fuse box is located under the rear seat cushion
2,950 views
Usually answered in minutes!
×