Which Fuse do I replace for a 1999 Mercedes-Benz CLK430the brake light

SOURCE: Mercedes Benz C180 Fault Message Brake Assist.Visit Workshop BAS

Hi there

BAS is the Brake Assist System and if there is a malfunction it would only come into play in an Emergency stop while applying full pressure. BAS applies full braking force because people tend to lighten up their pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.

Kind regards
Dustin Ellse

SOURCE: 1999 mercedes ml320 brake lights don't work

did you check to make sure the wires going to the pedal switch are not cracked or burnt?

SOURCE: Replace Cabin Filter in my 2002 C240 Mercedes Benz

I have a 2002 C240 Mercedes and need to replace the cabin air filter. Problem, I don't know were it is located or how to replace it. Can you help me.

SOURCE: I have 1999 Mercedes Benz e300 Turbo Diesel and

Hi there
Its probably not a fuse issue as that would affect both sides.
when you replace a blub especially the brake lights it is possible to deform that nice flat panel of metalic strips and if you look carefully it sometimes breaks the plastic pins on which it sits, this causes poor connection to the functional bulb, the soloution is easy, get a small piece of card and fold it over till its about 2-3 mm thick then wedge it behind the panel of strips (top outside corner for brake light) and hey presto the light should work again, top tip use an umbrella and the electric seat to make sure the brake pedal is deppressed to check if alone.

mx5turbo92

• 545 Answers
• Posted on Dec 17, 2009

SOURCE: i need the mercedes benz 1999 clk 430 radio code

AR82.60-P-7502-01A Coding Radio
(MODEL all with CODE (750) Radio Becker Europa 2000 with CODE (751) Radio Becker Grand Prix 2000 with RDS)

1. If the radio is disconnected from the power supply, it is not operational when re-connected. After switching on the ignition and the radio, the readout CODE appears in the display.
2. The code number for the radio is advised to you on the enclosed CODE CARD.
3. To enter the first digit of the code number, you have to continue pressing station button 1 until the correct digit appears in the display. Adopt the same procedure for the second, third and fourth digits.
4. Once you have entered the correct code number with the station buttons 1, 2, 3, 4 and confirmed the entry with the SEEK button (press down), the readout CODE disappears. The radio can now be operated.
5. If you enter a wrong code three times, you must wait 15 minutes before making a new entry. In addition, if 9 incorrect entries are made, the radio will then not operate for 24 hours. During this time the radio and the ignition (terminal 15) must remain switched on.

1. If the radio is disconnected from the power supply, it cannot be operated by simply reconnecting. After switching on the ignition and the radio the word "CODE" appears in the display on the radio.
2. The code number for the radio is given on the enclosed CODE CARD.
3. Enter the code number with the station button, e.g. number 1, station button 1. After entering the first number the word "CODE" disappears and the number entered appears followed by 4 dashes. The next character to be entered flashes. After entering all five numbers, the first character starts flashing again. In this state the code number can be written over as frequently as desired. A correction can be made only by entering the complete code number again.
4. Confirm code number: Press TUNE, AUTO/SEEK or SC button. The radio automatically switches on and indicates the radio station or frequency stored with station button 1.
5. If an incorrect code number is entered and confirmed, the word "CODE" appears again on the display. If an incorrect code is entered three times the word "WAIT" appears on the display and the radio locks up for approx. 10 min. If the code is entered incorrectly three times again the radio locks up again for 10 min. Three more incorrect entries (a total of 9 incorrect attempts) increase the lock-up time to 60 min. Another three incorrect entries lock up the radio for another 60 min. The waiting time runs only when the radio is switched on.