I need a schematic for the ignition on my 2000 Pontiac Bonneville SLE. When I try to start it it won't turn over.

I had the same problem. Found the problem was within the coil. Replaced coil

Auto parts store will gladly match replacement part for your car, but how are you going the do the replacement. Mechanics may not install your purchase, as it affects profit for them!

how do i put air in my air shocks on 2000 sle bonneville

I had the same problem with my 2000 Bonneville SLE and I replaced the crank shaft sensor and it solved the problem. The crank shaft sensor is located behind the harmonic balancer. You have to take the balancer off to get to the part. You will need a puller to get it off. You will also have to take the fly wheel cover off and hold the fly wheel when you remove the nut from the front of balancer.

A screwdriver should do it. It's sitting on top of the throttle body as shown below.

You probably have it fixed by now, but you should have a 3.8L V6 (no supercharger).
The belt routing should be the same as my Impala 3.8L.

I would check to see if the spark plugs are fouled. Or you might have a bad ignition control module (mounted under the coil packs). Auto Zone can test the ignition control module.

mass air flow sensor is located on the air hose that leads to the air filter if you have the part just look for the same look to make sure.

THIS PROBLEM IS ONLY CAUSED BY ONE THING, AND THAT IS A DEFECTIVE GAS GAUGE SENDING UNIT IN THE GAS TANK

Mechanic replaced the MAS. Car still idles a little rough and battery needle gage still fluctuates.