I have problem with my Hyundai Tuscon CRDI 2006, injector no 3 &4 are stuck cannot remove them- I have already taken out no 1 & 2 any ideas please on how to remove them

SOURCE: Hyundai Santa Fe diesel crdi

Check exhaust emission control system and catalytic converter.
These items have been integrated into a highly effective system which controls exhaust emissions while maintaining good driveability and fuel economy.

PAUL MC G

• 1280 Answers
• Posted on Oct 04, 2009

SOURCE: where is the computer box of the 2006 hyundai

If it's anything like the Tiburon, there are two different locations, depending on which engine you have. The 2.0 liter 4 cylinder computer is located under the dash, driver's side, near the steering column shaft...




On the 2.7 V6, it's located on the passenger side, front A pillar near the glove box..

SOURCE: number one injector bank on 2006 dodge cummins

you'll notice on your valve cover gasket there is two connectors.. the one up front is your 1-3 the one in the rear is your 4-6... you can remove your valve cover and check the connections from the injector connectors to the
connectors on the valve cover.. check for an open.. however you could also have a fault internally in 1 of your injectors in that bank as well.. hope this info helped..

SOURCE: How do I remove the back bumper from a 2006

take help of the following steps to remove rear bumper on ur tucson.

Open the trunk of your vehicle.

1. Unscrew all the screws on the inside plastic trim that covers your bumper to trunk connection.
   
2. Pry the plastic piece out with a flathead screwdriver. You will expose the bolts that attach the rear bumper to the trunk.
   
3. Unscrew the bolts connecting to the inside of your rear bumper. There should be four bolts.
   
4. Unscrew the two to four screws connecting to your bumper from the inside of the rear wheel tire wells. These screws are on the area of the tire well that is closet to the bumper.
   
5. Slide under the rear of your car. Use a flathead screwdriver to pop the plastic rivets out of place along the underside of the rear bumper. There should be four to six rivets.
   
6. 
   Squat behind your car and firmly pull the bumper off. There will popping plastic sounds, this is the pop-in-place plastic rivets that are the last pieces that hold your rear bumper in place.
   

Martin

• 206 Answers
• Posted on May 30, 2011

SOURCE: how to remove fuel injector in hyundai accent crdi

Remove injector pipes, then rocker cover and you will then see injectors inside, secured by a clamp and bolt on each cylinder.