Question about 2002 Isuzu Rodeo

2 Answers

HOW DO YOU RESET THE TPS SENSOR ON A 02 RODEO AFTER YOU RELPACE IT WITH A NEW ONE

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 6,098 Answers

Scanner if not battery off 5 min.

Posted on Oct 11, 2016

Testimonial: "THAT DIDNT WORK"

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 20,706 Answers

Wow,no engine stated or if its the SPORT model.

why not say why you think it needs resetting?
"that didnt work", well what did it not do that you expected
not ONE WORD on expectations./ zero.
like pulling teeth.
no symptoms stated, or reason doing this.... sad.

there are only 4 ways on all cars.MADE (a generic answer )
Ive done them all so know them...
1: JUST put it on and and PCM learns it. (BINGO)
2: put in it and set it to 0.5v. (throttle angle voltage , idle)
3: put it and and set trip point , with feelers. (1988'ish like)
4: takes factory scan tool to set it. (bad news, if true)
each car is different. each EFI system. each engine, and year generations (and laws)

now ill do your job and look it up at mitchells.
usa cars only. (I dont do Holden cars down under)

the 2.2L book says put it in , done.
3.2L same. words
3.5L whole throttle body is changed to get new TPS and same words, bolts on , no adjustments.

so now, be the time to fess up an tell the full story
my wild guess, is car runs bad,. some dweeb on the net said
put in new TPS? in most cases they are all wrong.
and you did and not better running.?

like 10,0000 post here like that. endless. in all ways every time.

Posted on Oct 17, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

02 sensor? Throttle Pos Sensor?


Likely the TPS.. those cars were notorious for chaffing or breaking wires. The 02 code is likely a result of the bad TPS. Or, having a bad tps may have even clogged the sensor.

Mar 09, 2014 | 2001 Chevrolet Malibu

1 Answer

I replaced the throttle position sensor on my ,02 hyundai santa fe,now it will not shift gear and check engine light is on with throttle position sensor circuit A high voltage, how can I fix this


how did you know the TPS was bad? did you break anything (vacuum tube, wire connector) during repair? good ground? was it really clean in there when you installed new TPS? i don't know the santa fe, but did you disconnect the battery during this? you may have to reset the OBD system. if you have the OBD tester i think it has this function, or check usere manual, possibly a combination of actions involving ignition, shifter and/or lights.

Sep 16, 2012 | 2001 Hyundai Santa Fe

1 Answer

How to change tps sensor by pedal


your TPS is not at the pedal, it is on the engine right where throttle cable connects. look for plug with 2 or 3 wires on it. there will be 2 screws or bolts holding it in place. mark the housing before you take the old one off, new one must be put back in same exact place.

May 26, 2012 | 2002 Isuzu Rodeo

1 Answer

Were iss the tps sensor on my 2004 isuzu rodeo


the tps sensor is located on the throttle body.were the throttle cable connects to the accelerator lever,its on the opposite side of were the cable connects to the lever and the will be an electrical plug connected to it.

Sep 16, 2011 | 2004 Isuzu Rodeo

1 Answer

How to replace Isuzu Rodeo 2000 TPS Sensor? can i have a pic of TPS Sensor?


TPMS sensor? If so the TPMS sensor is in each wheel and is part of the valve stem. The tire must be broken down and seperated from the rim you will need a garage with a tire changer for this. The new sensor just simply screws in place and is torqued down as stated in the specs and recoded for your vehicle. Again a special tool is needed for this. BEst bet is to take it to a qualified garage as it will only take them about 20 mins to do this for you plus the cost of the sensor.

Best of luck!

Oct 09, 2010 | 2000 Isuzu Rodeo

1 Answer

Location of tps and map sensor on a 02 jeep grand cherokee 4.7l


Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.

May 07, 2010 | 2002 Jeep Grand Cherokee

2 Answers

Check engine light. code po141 codepo122


po141, may be a bad o2 sensor, rear sensor after converter. the po 141 is low voltage to tps, try replacing the oyxgen sensor first and then reset the codes and drive if the po141 comes back then replace the tps,

Apr 15, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

What part is needed on an 03' Rodeo that trouble


P1290 = Elec Throt Control Particulate Bank 1 Idle, This means you could have a problem with your throttle body. You will need to monitor your tps sweep on a scan tool to check for spikes. Sometimes this code is set when the battery is disconnected and resets adaptations.

If it keeps coming back, you most likely have a bad TPS sensor.

I hope helped with this (remember rated this help). Good luck.

Nov 24, 2009 | 2003 Isuzu Rodeo

1 Answer

RODEO 99 ECM PROBLEM


that can happen for several reasons the least being the ecm. first thing is it could be a weak fuel pumpand the only way to check this is with a fuel pressure gauge. it should be between 17 and 25 psi. next it could be the TPS(throttle position sensor) this controls your idle. this is located on the throttle body has a weatherproof plug and is held with (2) screws . next is the engine speed sensor this helps the ecm adjust the fuel/air mixture in conjunction with the TPS,IAC valve,O2 sensor<and the egr valve. to pinpoint the sensor problem you have to have a diagnostic scan done. please rate this.......thanks

Sep 23, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,032 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

459 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...