How do you change a fog light cover in 2002 Dodge Neon

you will have to remove wheelwell liner to gain access to inner bumper cover.Lights are fastened from inside cover

fog lihts or daytime lights.. some are relay controlled some are automatically off of the ignition switch through a relay..check these..

you have to remove the valve cover and flip it over to access them, best off to get a new valve cover gasket as well.

you can take loose the black plastic shield that runs from inner fender to bottom of bumper. once loose you gain access to back of fog light where mounting bolts are located if its just the bulb your replacing you can also do that without removing it

To replace the fog light of the passenger side you need to remove the fog light bolt and pull out the fog light assembly, then you can remove the bulb and put a new one in.

To replace the fog light on the driver side you will need to remove the front bumper cover so you can remove the vacuum box that is in the the way of the fog light bolt.

To do so you need to remove the Torx (star) screws located in the front wheel wells as well as the bolts holding the plastic by the radiator. "CAUTION: DO NOT UNBOLT THE RADIATOR."

If any of the screws are rusted into place put some penetrating oil them to help loosen them up.

PLEASE DON'T FORGET TO RATE!!!

you should be able to slide the cover off some times you have to squeeze the sides to undo the cover

you need to remove the 2 nuts from under the fascia that hold the assembly in. this will give you access to the bulb

there is no recall on the lights sorry

there are no recalls on a 2004 neon

if you look directly under the bumper just under the fog light you will see a bracket that holds a 13 mm bolt. undo that and pop the light out from the front of the bumper and replace the bulb. install is the reverse