2000 Honda CR-V Logo

Related Topics:

d
donnie decker Posted on Oct 08, 2016

How do i disconnect alarm on 2000 honda crv - 2000 Honda CR-V

1 Answer

bigdave7

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 40 Answers
  • Posted on Nov 23, 2016
bigdave7
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that hasĀ over 10 points.

Joined: Mar 15, 2011
Answers
40
Questions
0
Helped
11381
Points
65

You can cut the power supply to it by removing fuse or cun power supply from batt.

  • Edna Paul
    Edna Paul Dec 07, 2020

    Will this make my car start

×

2 Related Answers

Anonymous

  • 77 Answers
  • Posted on May 07, 2009

SOURCE: need to put transmission fluid in my crv honda 2000 i would like to know what is the best type of fluid

You should just go to Honda and purchase it from them. You can go up to the parts counter and either give them your year/make/model or your vin and they will give you exactly what fluid(its the same on all A/T honda's) and the correct amount need. They made the car, they know best.

Ad

Anonymous

  • 5081 Answers
  • Posted on Feb 14, 2011

SOURCE: need code for 2000 honda crv radio. changed

Radio code is specific for each and every car. It is specific like anti theft code. You can get it by providing your VIN# and registration details in authorized dealership. Nobody else can provide you. If anybody can provide you that , then there is no meaning of security for your car.

You can verify an satisfied customer in the below link
www.fixya.com/support/t6842407-bought_2003_honda

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I disable my anti theft mode on a 2000 Honda CRV after replacing the battery

Normally unlocking the vehicle from the drivers door with the key should turn off the alarm system
0helpful
1answer

Why my 2000 honda crv doesnot have heat on the winter time?

check the controls that open the heater lines . vacuum loss or control module is faulty.
0helpful
2answers

Fuse diagram 2001 honda crv

On this website, you find fuse box diagram and description Honda CR-V (2000 -2001)

Honda CR 2000 2001 fuse box diagram Auto Genius
2helpful
1answer

Reset car alarm honda CRV

Put key in ignition and turn forward to start electrical system, but not the engine.
Turn key back one click.
Push the button on the alarm box under the steering wheel (sometimes by parking break) three times (3x)
You will hear two beeps of the horn confirming the change. You are done.
0helpful
1answer

I haven't driven my 2000 Honda CRV in about a week. When I tried to unlock it this morning neither of the remotes would work. I can get into the car manually unlocking the doors but the engine won't...

It sound like the keyfob remotes turn your alarm off on the vehicle. The starter disable part of the alarm is preventing you from starting your car. You will have to get your remotes fixed. Might just need batteries...
0helpful
2answers

On a 2000 Honda CRV, how do you reset the service light?

Needs to be done with a scaner to reset light, most repair shop can do this, you could also try autozone, they can do this for free, do not disconnect battery or it could ask you for a radio code, and if you don't have the code, your going to have a hard time getting it.
0helpful
1answer

2000 honda crv no spark and tach shows no rpms while cranking over?

Sounds like you may have a defective Crankshaft position sensor. You might try checking the connector that goes to that sensor and make sure it is plugged in properly. Always disconnect the battery before doing so.. Good luck
2helpful
1answer

Honda crv 2000 computer reset

Ok,
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps
Not finding what you are looking for?

1,088 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...