Re: WERE IS THE SIGNAL LIGHT FLASHER RELAY 97 GRAND...
It should be located on the fuse panel which is located on the passenger side under the kick panel where your feet go under the dash. Hope this helps you out
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
test the combo switch,
get the schematic,
then with a voltemeter probe the input to combo and output.
if imput is good, and output is bad the switch is bad.
alldata.com has the schematic.
the FSM even walks you step by step to each test.
Two FLASHER applicatiosn there:
Hazard flasher: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center
Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted in convenience center
If you need additional details or some repair manual sections, just send us a new comment.
Hope this helps (remember to rate and comment this answer).
Check the postion F4 / 15 Amp ( Lt. Blue ) Flasher, hazard switch (see Junction Block diagram above for location of turn signal Flasher relay - Mopar p/n 4686094)
in your vehicles owner manual, look up fuses, and flasher units or flasher relay. Fuses are normally located under the dash, but when both turn signals quit working it is usually the relay. The relay is located under the hood yours owners manual should show you the location.
I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING
If you still have flasher problems, I read on Google to spray WD-40 down in and around the hazzard flasher button, then press it up and down several times...and BINGO...all flashers and signals worked again....just had some dirt and dust in the wiring....
×