How to torque crank top and main bearings and bigends bearings on Hyundai 1400 petrol 12 valve 1996 m0de

SOURCE: acura integra engine torque specs

56 ft lbs torque main bearings, NON v-tech engine.

SOURCE: cylinder head torque settings for a toyota 1493cc

If you have a vehicle application for the motor you can get a Haynes or Chilton manual from your local auto parts store. They usual run around $30.

SOURCE: Torque specs for 96 Honda Accord 2.2L

the main bearings bolts is to 1st step 30Nm or 22lbs ft and the last step is 75Nm or 54lbs ft in this tighten secuence. 9 3 1 5 7 on the top bolts and........ ........ ........ ... 8 6 2 4 10 botton bolts and the connecting rod 45Nm or 34 lbs ft i hope be help you

SOURCE: need torque specs for connecting rod and main

Torque in two to three stages.
Connecting rods are 24-26 lb.ft.
Main bearing caps are 41-44 lb.ft.
Hope this helps,Chuck

Testimonial: "Thanks for the help Chuck"

SOURCE: mitsubishi canter truck 4d34 torque settings

Hi!!!
Most manuals I found do not cover diesel engines. There is a Peter Russek manual for your truck which covers diesel engines. Click on the following link to check the manual http://www.auto-repair-manuals.com/Mitsubishi-1997-2002-L200-2WD-4WD-2-0L_2-4L-Petrol-2-5L-Diesel-Russek-Repair-Manual.html
THIS ARE THE SPECS FOR A 04 MITSUBISHI LANCER. Identifying Fastener Tightening Specifications Table ITEMS SPECIFICATIONS Roll stopper bracket mounting bolt69 ± 10 N.m (51 ± 7 ft-lb) Shift cable bracket mounting bolt19 ± 3 N.m (14 ± 2 ft-lb) Select lever mounting bolt19 ± 3 N.m (14 ± 2 ft-lb) Speedometer gear mounting bolt4.0 ± 1.0 N.m (35 ± 9 in-lb) Backup light switch32 ± 2 N.m (24 ± 1 ft-lb) Interlock plate bolt30 ± 3 N.m (22 ± 2 ft-lb) Poppet spring32 ± 2 N.m (24 ± 1 ft-lb) Control housing mounting bolt19 ± 3 N.m (14 ± 2 ft-lb) Under cover mounting bolt7.0 ± 1.0 N.m (61 ± 9 in-lb) Reverse idler gear shaft mounting bolt48 ± 6 N.m (35 ± 4 ft-lb) Clutch housing-transaxle case mounting bolt44 ± 5 N.m (33 ± 4 ft-lb) Front bearing retainer mounting bolt19 ± 3 N.m (14 ± 2 ft-lb) Select lever mounting nut12 ± 1 N.m (104 ± 9 in-lb) Stopper bracket mounting bolt22.3 ± 0.3 N.m (16.1 ± 0.2 ft-lb) Clutch release bearing retainer mounting bolt9.8 ± 2 N.m (87 ± 17 in-lb) Differential drive gear mounting bolt132 ± 5 N.m (98 ± 4 ft-lb)