SOURCE: power door lock switch replacement
Remove or Disconnect
Door handle trim plate.
There May Be A Need to Drill Out RIVETS that Hold Motor in place,. Just Replace with>>MACHINED SCREWS & BOLT'S
Remove or Disconnect
Install or Connect
SOURCE: 1992 park ave transmission slips fluid and
It probably did not slip before the fluid was changed I so the clutches are worn out and need to be replaced The worn fibers were still in the old fluid causing the fluid to be thicker filling the voids much better to shift. Now once drained and new fluid installed it slips
Hello Robert, you could have a bad oil sender unit. Install an auxiliary oil pressure gauge to measure the amount of oil pressure. If reading is around 15 PSI or better at idle, change the oil sender unit.
158 views
Usually answered in minutes!
×