Body control module location 2008 jeep liberty

SOURCE: 2003 Jeep Liberty heater fan problem

It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

SOURCE: how to change oil filter on 2008 jeep liberty 4x4 ?

yeah they will say that and it may be your last choice but I know it is in the front of the engine and you need a long extension and ratchet handle and a claw type filter wrench to get it. Worth investing in if your going to do it all the time yourself. but prob not for one time.

SOURCE: Jeep Liberty Air Conditioner not blowing out air

out off freon. bad ac clutch. or bad switch on dash.

SOURCE: I have a 2008 Jeep Liberty sport it has 39600 back-up lights not

If you have tested fuses and bulbs with test light,and they check out,
the next step is to put you jeep in reverse with the key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light switch on trans,if you find no problem there,replace the switch

Testimonial: "Thank you for the info on my jeep. I brought it to my mechanic and he could not find where the new switch goes.I will bring it to the dealer."

SOURCE: Engine serial number location

Service manual says for six cylinder 3.7, the number is located on the right side of the block near the front. I have been looking myself but havn't found it yet. I havn't found any pic or diagram to show it either. Please have a look and post if you find it.