How do I remove the center console on my 1997 Oldsmobile Cutlass Supreme?

SOURCE: 1998 Oldsmobile Cutlass Supreme Blower Motor

It's not to hard to do, just have to lay upside down in your pas. floorboard, remove plastic panels under gloove box with small nut drivers,(can't remember size) then there are three hex head screws holding on the blowerplus the wireing connector, anf it has a wierd rubber gasket, hope this helps.

SOURCE: 1997 oldsmobile cutlass supreme knocking noise & problems acceler

That could be only two things one a bad pistion or a bad rod. I would take the engine apart and find one or both maybe broken or in bad repair fixing. I would not drive it far it will throw the pistion or rod right through the engine costing ya more money or a new car.

machinehead2

• 14 Answers
• Posted on Jan 10, 2009

SOURCE: 1994 oldsmobile cutlass supreme will not start.security flashes

Sounds like a RFID issue. Your key most likely has a chip inside of it. Most of the time people will have multiple keys on their key chain that can cause interference with the receiver in your steering column. Try using the one ignition key to start.

SOURCE: Where can I find a spark plug wiring diagram for 1997 3.1l engine

Normally the firing order will be stamped on the top of the intake manifold also the number one plug will be the front one on the drivers side of the car. On the top of the distributor cap you should see a number one that is where the number one plug wire goes follow the firing order on the manifold and go clock wise on the distributor cap

SOURCE: 1994 oldsmobile cutlass supreme sl the fuse box for signal lights

the fuse box will be in 1 of 3 places (1)glovebox (2)under dash by drivers foot kick panel or (3) under hood .