Where is the airconditioner inlet located on a 2002 grand am

The EVAP purge solenoid is located under the hood on the left fender (as seen from drivers position).It has two small lines going to it, one from the engine inlet and the other is going to the EVAP canister.

coolant temp sensors are usually located on the outlet or inlet of the cooling system...look for your upper radiator hose and follow it to the engine you should see a sensor mounted into the alumnum or steel housing...

keep in mind you also have a temp sensor for the gauge in the dash, that one is usually located on the head but that only controls the gauge not the fans...

good luck

could be a leaf inside the inlet box to the fan assembly.pop the hood and its located just under the wiper arm panel.

the radiator hose on the top area of the motor comeing out of the radiators top will be what you are looking for it has the inlet right where the hose hooks up to the motor remove the pressure clsp and the hose from the motor then it hase two screws where the inlet on the motor is being held in place remove those screws inbetween this area you will find your thermostat

3 inch

hi its located directly under the throttel body my tip take the throttel body off this makes it easier getting to the inlet manifold top bolt is ok but the bottom bolt can be hard good luck if you find this imfo useful please rate it thanks

Exploded view of the thermostat arrangement—3.8L engines

climate unit is bad

The dual air on this car has two temp control motors that are electronic. You need to have the car scaned at a dealer to see if it has a code for the left temp feed back circuit. If so you will need to replace the temp control motor for that side.Good Luck

The air door actuator on the offending side needs to be replaced.