2003 Hyundai Santa Fe Logo

Related Topics:

Carlos Viteri Posted on Sep 24, 2016

Santa Fe 2003 2.7 where are the transmission band adjusting bolts?

5 Related Answers

Anonymous

  • 21 Answers
  • Posted on Jul 02, 2008

SOURCE: 2003 santa fe

It needs a new pruge valve. The purge valve is sticking open allowing fuel vapors into the intake manifold causing a rich hard start condition.

Ad

Anonymous

  • 21 Answers
  • Posted on Oct 19, 2008

SOURCE: transmission filter on 2003 hyundia santa fe

In 2002 they discontinued the external trans filter. So your vehicle could have the external filter. If you look next to the trans dipstick tube, on top of the trans case you will see the filter or you will see just a spot where the filter use to go before they eliminated it. Yes, the filter does llok like a regular engine oil filter. If the trans does not have the external filter ontop then there is no service to the filter to be done, the only recommendation is to bring vehicle into a shop to have the fluid flushed. By the way, make SURE you use the correct Hyundai SP-III trans fluid (not dexron/mercon). This fluid is specific to the Hyundai and can not be purchased from auto parts stores, only the dealership. Failure to use SP-III will cause premature wear to the internal bands and clutches.

Anonymous

  • 1990 Answers
  • Posted on Jan 23, 2009

SOURCE: The rear hatch on my 2003 Hyundai Santa Fe won't stay up.

Yes. Your Local Auto Parts Store should Carry these as Direct Replacements. If Not, Sears Carries them.

tracer_steve

Steven Mitchell

  • 68 Answers
  • Posted on Apr 01, 2009

SOURCE: hyundai santa fe 2003 model

You need a new fan switch.

Anonymous

  • 223 Answers
  • Posted on Jun 15, 2009

SOURCE: 2002 hyundai santa fe transmission will not engage

You might have lost your lower gears, I would have someone look at it to see if your gears are gone or if its just a faulty sensor.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where are the adjusting band bolds in the Hyundai Santa Fe 2003 2.7. Automatic 4x4?

There is no adjusting band , that is older transmission like GM built and Ford.
0helpful
1answer

Torque bolts for flywheel 2003 Hyundai Santa Fe

94 -101 ft/lbs- dip the bolts in clean engine oil or use never-seize on threads. use new bolts
3helpful
1answer

My 2003 Santa Fe will not stay in 5th gear! I have a new clutch!!! What's up??

This is not a clutch problem this is a worn part in the transmission causing this, have the transmission removed and torn down and inspected to see what is worn out and affecting the 5th gear.
4helpful
2answers

Where is the transmission filter located on a 2003 Hyundai Santa Fe 3.5 liter 2wd?

The transmission filter is in the transmission covered by the Trasmission Pan. Need more help get back to me and we'll go from there Thanks Ray
0helpful
1answer

How do i remove a power steering pump on my 2003 hyundai santa fe. i removed the bottom bolt but i cant figure out how to remove the top bolt.

I presume your Santa Fe sports the 3.5 liter V6 engine? If it's got the NUT, it's at the front & there's a nut stud. If it's got the BOLT, it's accessed from the opposite (anterior) side using a long, long extension. If you have a vehicle hoist/lift, you can easily see it. If you're on your back with the vehicle on jack stands, it's much more difficult to see the 14mm bolt between the exhaust flex pipe and heat shield of the exhaust manifold at the right hand side of the engine.
Say you're directly beneath the engine oil pan, move toward the transmission and look upward and forward between the 1:00 and 2:00 oclock positions of the engine (toward the power steering pump) - 14mm bolt
0helpful
1answer

2003 Hyundai Santa Fe FWD transmission slippage

try resetting adaptive values to see if that helps. remove both battery cable terminals and hold them together for about 30 seconds to discharge all power. reconnect and drive.
1helpful
2answers

2.4l santa fe spark plug location

there are 2 covers that are over the plugs the first is the big silver and black cover that has four
10mm bolts remove them and then there is a small black cover that is inbetween the two humps on the valve cover i think that there 6 bolts that holdthat down remove this and the coils and plug wires are visable
0helpful
1answer

Hyundai santa fe 2003 model

You need a new fan switch.
11helpful
1answer

Transmission filter on 2003 hyundia santa fe

In 2002 they discontinued the external trans filter. So your vehicle could have the external filter. If you look next to the trans dipstick tube, on top of the trans case you will see the filter or you will see just a spot where the filter use to go before they eliminated it. Yes, the filter does llok like a regular engine oil filter. If the trans does not have the external filter ontop then there is no service to the filter to be done, the only recommendation is to bring vehicle into a shop to have the fluid flushed. By the way, make SURE you use the correct Hyundai SP-III trans fluid (not dexron/mercon). This fluid is specific to the Hyundai and can not be purchased from auto parts stores, only the dealership. Failure to use SP-III will cause premature wear to the internal bands and clutches.
0helpful
1answer

Parking brake

I just replaced rotors on my 2003 Santa Fe, There are 2 phillips screws in the rotor that must be removed. There is an auto adjuster on bottom of brakes. That inspection hole is very small! Sometimes you must tap a hammer around the drum to loosen the rust. Hope this helps.
Not finding what you are looking for?

61 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...