Fuel filter location Honda accord 2002 v6 - 2002 Honda Accord

SOURCE: 02 mustang fuel filter

their is a plastic cover on the drivers side under the car. you will have to take 4, 10mm bolts off and then you push the green clips and pull a same time and the filtler will come off

SOURCE: Fule filter location for a 92 honda accord ex

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528005f265

SOURCE: location of 98 honda accord fuel filter

Its located on fire wall its mounted on a bracket, its black in color so may be hard to see. Good luck and thanks for using FIX YA.

SOURCE: 2002 Honda Accord V6 check engine light on- local

po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy

SOURCE: change dashboard light bulb in 2002 Honda Accord EX V6

you will need fill up screw driver and a flat head remove the 2 screws that hole the BLK panel . then you use your flat head gently push up and out on the lower left and right coroners . be very carefull make sure you got time no rush. NOTE : make sure you go pick up the LIGHTS I USED sylvania lights part #74 LL YOU WILL NEED 14 OF THEM COST 4.99 FOR A SET OF 2 AND IF YOU HAVE AUTOMATIC CAR YOU WILL NEED CALL A HONDA DEALERSHIP AND FIND OUT IF THEY HAVE THE ONES THAT LIGHT UP WHEN YOU CHANGE GEARS.

• after you got the BLK panel off you will see 2 gold screw do not take them off.
• remove 4 BLK screw , two of them will be next to the gold screw . the other will be right on the top
• after you got the screws off
• stat pulling out the dashboard out slowly ..
• after you see that the dashboard dosen't want to come out you should be able to see these 3 green wire connection one on the left , right and one in the middle
• I use a long flat screw driver to push the small clip in the middle then at the same time push up.
• one you took off all 3 you can pull it out .(CAREFULLY)
• TWIST OFF THE SMALL BLK ONES OFF VERY EASY YOU CAN BUY AT ANY AUTO STORE . BUT FOR THE ONE THAT LIGHT UP WHEN YOU CHANGE GEARS IF YOU AUTOMATIC YOU WILL HAVE TO GET THEM FORM THE HONDA DEALERSHIP FOR THE WHT ONES I STILL don't know how to take them off . am going to see if honda can give me a hand .
• just to let you now am also changing the clock light and the Cruise control/TCS button light also
• O I for got change all the lights in the dashboard cause it is a b***h to take it off.
• hopefully this helps