SOURCE: How to remove wheel on 2001 bmw 325i
In the boot you'll find underneath the carpet, a spare wheel well. Containing a spare wheel, a jack, lever tool to remove the bolts and thats all you need. Make sure the handbrake is on and in gear to stop the car moving. Using the jack, you'll notice rubber jacking blocks on th underside of your car.
These points are where to jack the car up. Jack the car up so the its slightly lifted but the wheel is still touching the floor, this will make it easier to undo the wheel nuts. Best way is to put the wheel bolt removal tool and kick it down to "crack them off". Once all bolts loosened continue to jack car up till the wheel is clear off the ground. Remove all loosened bolts and replace wheel. Job done!
SOURCE: How to install front bumper cover on 2001 BMW E39
Installation
of the Molding
Take the Molding Trim whether it is
stock black or painted. Mine is black because my car is a year 2000.
Painted side moldings were done in the year 2001. Snap them into
place.
5 Installation
of the Rubber Gaskets
From the stock bumper, retrieve the upper
rubber gaskets unless you ordered new ones. Simply take a screw
driver and pry a corner off to get you started. Wash thoroughly.
NOTE which one belongs on which side.
Place the rubber gasket on the M5 Front Bumper onto
its appropriate side. Top
The M5 Bumper is now Fully Assembled!!!
Place aside where it can't be damaged.
SOURCE: bmw 318i 2001 model just stopped while driving
you have problem with tank mybe is dirty and you must check fuel filter and fuel pump
SOURCE: Describe your BMW 2001 325 Problem car hesitates
this problem could be cause by a few things, the first thing to check would be the operation of the air fuel sensor and the next thing i would look at would be to check for proper fuel preasure. the preasure spec is 50psi. and the volume spec is that it should pump at least 1.85 L in 30secs.
Testimonial: "Thanks, I will look into this. Great turn around time..."
SOURCE: I have a 1998 BMW
Do you have an owner's handbook? What happens is that they use a rod that looks like a big screw. If that track has been damaged in any way, it can bind and may require excessive force to close. The manual indicates that some resistance is felt at the halfway point and that if if triggers it to retract, to hold the button forward. If this does not work, I would push with my hand while holding the button til it is closed. The headliner may have to be removed to gain axcess to be repaired. Let me know on the owner's handbook and what you find with the sunroof.
76 views
Usually answered in minutes!
×