SOURCE: remove and replace metal brake lines on driver's side.
There are two(2) compression fitting nuts on each end.
Find the size open ended wrench that fits EXACTLY and loosen them up, take the old line off, and replace it the exact way in reverse. Tighten the nuts to seal the ends.
Then have someone help you bleed the brake lines to get the air our of them.
I hope this helps you
Thanks for letting FixYa.com...fix ya
Terry
SOURCE: What fuse can be removed from a 1989 Pontiac Bonneville?
Any fuse marked "ignition" or "ECM"
SOURCE: Remove driver's-side mirror on 2003 Pontiac Bonneville
Remove the small triangle panel in the corner of the window, one clip. then to remove all of the door panel you can pry starting at the bottom and work to the sides. once all push clips are off. (they really sound bad when they come loose, but that is normal.) push the panel up to remove the last two holders behind the door handle. You will have to remove these later with a needle nose pliers and slide them back on the door panel before you reinstall. remove elect from block and remove the Three screws holding the mirror. they are 10MM I think. and the mirror will practicly fall our. Or just hit something with it like my wife does and they come off pritty easy.
SOURCE: Will a 1997 pontiac bonneville transmission work
THAT CAN BE THE CASE, THE GEAR RATIO CAN BE DIFFERENT, JUST AS THE REAR WHEEL DRIVE CARS, AND YOU NEED TO BE CAREFUL. THE ELETRICAL CAN BE DIFFERENT ALSO, GET THE SAMME YEAR, MOTOR SIZE.
So there are obvious drips on the floor then?
Assuming those two which you mentioned are fine, then the other most probable and common oil leaks are from:
Rocker cover gasket(s)Front or rear crankshaft oil seals.
56 views
Usually answered in minutes!
×