SOURCE: Turn signals dont work headlights dont dim heater fan doesnt work
Did all these problems happen all at one time?? If so you may have a bad body ground. Try running a electrical wire from the (-) negative side of the battery to the body and see if this works. Be sure this wire is to a place with no paint as low voltage electricity will not flow through paint.
A). If not try replacing the turn signal flasher for the turn signal problem. This is usually the culprit and it's easiest and cheapest to replace. The turn signal flasher will be found under the driver side dash next to the hazard flasher. Turn the hazard flasher one to locate it. If you want try swapping the turn signal flasher with the hazard flasher to see if this fixes it. They are the same style flasher.
If this doesn't work you may a faulty turn signal switch or some wiring issues.
B). It could as simple as the head lights bulbs need to be replaced, it's rare but I have seen when both bulbs blew at or near the same time. If your able check the voltage at the head sockets.
C). Could be a bad blower motor or switch. I'm not sure if these models have a resistor block or not. The resister block controls the electrical current going to blower motor which controls the speed of the blower fan.
SOURCE: How do you access the
if their is a engine cover take cover off / their are 2 bolts for the headlight take them out and pull the headlight forward
SOURCE: jetta headlights not working
Ignition switch will cause you to loose your head lights and turn signals. You will still be able to start the car and hold the switch for your brights but normal function is gone. Check it out it usually only runs about $20-$30 for replacement part but you need a special puller to get to it.
SOURCE: turn signals dont work
For 1993 Oldsmobile Cutlass Ciera 3.3L FI OHV
6cyl. you have two flasher units, one for Hazard Light and one for Turn Signal...
The hazard flasher is located in the convenience center, under the dash,
on the left side kick panel. The turn signal flasher is installed in a
clamp attached to the base of the steering column support inside the
car. In all cases, replacement is made by unplugging the old unit and
plugging in a new one.
Hope this help (remember comment and rated this help).
391 views
Usually answered in minutes!
×