What is the torque setting on almera qg16 conrod bearings?

SOURCE: internationl 345 v8 torque settings

Head bolt torque: 90-100 ft lbs., to be reached in 3 equal tightening steps, below is the sequence:
9 3 1 6 8
Front of vehicle
7 5 2 4 10

Main bearing cap torque: 75-85 ft lbs.
Rod bearing cap torque: 45-55 ft lbs.
Looks like u've been busy, and will be for a while. Good Luck!

SOURCE: torque settings for wheel bearing

120Nm on all A3s with standard wheels.

SOURCE: torque for 85 econovan 1.8 fe motor

a 1.8 in an 1985 econoline van i'm pretty sure that a 240ci inline 6cyl was the smallest engine these use now if you mean 5.8 this is what you want cyl hd.105-112 ft lbs rod blts 40-45 main bearing 95-105 imtake manifold 23-25 good luck

SOURCE: torque settings for a hyundai accent 1500 1998

cylinder head bolt torque

52-55 ft lbs. cold engine
59-63 ft lbs. hot engine

connecting rod cap nut 26-28 ft lbs. SOHC
connecting rod cap nut 23-26 ft lbs. DOHC

main caps 41-44 ft lbs.

Colin Stickland

• 22516 Answers
• Posted on Feb 25, 2012

SOURCE: torque settings conrod bearing 2e engine

tighten with a rachet and a decent socket with the shape of the nut in the end ,tighten to about a grunt and a slight arm muscle strain which is about 50lbs ,in two staged in the book it says 22nm +90? which to me is a load of hog wash ,make sure the shell with the hole in it for the oil spray is in the top con rod end and bit of grease in their as well before you fit the bottom one then a pull down first time with a rachet to firm pull then the second pull ,then turn engine over to make sure its not locked up then do the next one ,the lips in the shells that hold the shell inside the caps normally go together on one side and the con rod oil spray hole should spray towards the thrust side of the piston .