I have a 2008 Dodge Durango, tail lights and plate lights don't work, I have checked the fuses, all checked out fine.

Its the fuse or corrosion check for acid build up in side the connector clean it out with carburetor cleaner dry with soft cloth problem fixed

Did you check the taillight/dashlight fuse?

Your tail light/license plate light fuse is blown. Replace that fuse and you will have your running lights once again.

it could be a bad ground in the tail lights

i had the same problem with my 98 dodge durango if u have a trail plug undo it take out your tail lights and unhook it

Use a 12 Volt test light at the tail light connector and see if power is present at the harness, this would indicate a possible defective bulb socket.

OK there is a short in your car
take all the light bulbs out of the light that trigger the problem this break the current place one bulb in at a time checking that the fuse has not blown this will pin point where the problem is
once you find the problem you can replace the socket as it may have started to corrode check for water
once you replace the socket you should not have a problem
if you do let me know
dj_ricko_1988 at hot mail dot com

I KNOW YOU HAVE AN ELECTRICAL SHORT.WAS AN ALARM INSTALLED OR ANY OTHER TYPE OF ACCESSORY? CHECK WITH DODGE TO FIND OUT ABOUT A RECALL.IF SOMETHING WAS INSTALLED, TAKE IT BACK THERE TO STRAIGHTEN IT OUT IF NOT HAVE A AUTO TECHNICIAN CHECK IT FOR YOU.

where is the dome light bulb located?

well yes i would check all the fuses first