2007 Dodge Caliber 2.0 cooling fans relay location

Question re-written for clarity.
Question moved to model category.

There aren't any. The headlights are a function of the IPM (integrated power module). Fuse 36 is the control according to this.

Headlamp / Washer Control / Smart Glass

What's the 2007 Dodge Caliber headlight relay location?

Vehicle History https://www.vehiclehistory.com > questions > whats-th...
Jul 16, 2020 - The head lamps are controlled by a fuse in the engine bay. To locate the integrated power module, open the hood and look on the driver's side of ...

2 answers · Top answer: The 2007 Dodge Caliber is noted for driver's side low beam headlights that f

Dodge Caliber (2006-2012) fuses

Fuse Box Diagrams https://fuse-box.info > dodge > dodge-caliber-2006-2...

Fuse box diagram (location and assignment of electrical fuses) for Dodge Caliber (2006, 2007, 2008, 2009, 2010, 2011, 2012).

Fuses and relay Dodge Caliber - Fuse box diagram

fusesdiagram.com https://fusesdiagram.com > dodge > fuses-and-relay-d...

Locate fuse and relay. Fuse box diagram. Identifying and legend fuse box Dodge Caliber 2007-2012.

..

check and test fans and coolant sensor

There isn't one!

Fuse box Dodge Caliber - Fuses box diagram

https://fusesdiagram.com > dodge > fuses-and-relay-do...

Locate fuse and relay. Fuse box diagram. Identifying and legend fuse box Dodge Caliber 2007-2012.

Fuse Box Diagram Dodge Caliber (2006-2012) - Fuse-Box.info

https://fuse-box.info > dodge > dodge-caliber-2006-20...

2007, 2008 - In this article, you will find fuse box diagrams of Dodge Caliber 2006, 2007, 2008, 2009, 2010, 2011 and 2012, get information about ...

The TIPM control turn signals

The Totally Integrated Power Module (TIPM) is the gateway or distribution box for nearly the entire electrical system in late-model Chrysler products. Its main purpose is to take the commands from various switches and other modules and send those commands in the form of voltage or ground to wherever it needs to go.

All explained here

https://www.caliberforumz.com/threads/turn-signals-not-working.24492/

..

It is in the under hood fuse and relay center.

First try a wire straight to the fan from the positive battery to the fan keep you hands away from fan if it turn on check your. Fuse if ok try fan relay

drain coolant disconect radiator hoses remove cooling fans remove fasteners holding condenser to radiator position condenser away fron radiator remove radiator by lifting up be careful not to dammage cooling coils

TYou will have to put the vehicle up un ramps, because the fan assembly must be removed from the bottom rather than the top of the radiator. The Caliber has an electric cooling fan which, which must be disconnected electrically before removal. Then remove the fan shroud from the radiator. Drain the radiator by removing the lower radiator hose (you may be able to reuse this coolant later). The remove the upper radiator hose and the tube going to the coolant recovery tank. Unbolt the radiator's mounting bolts , and either lift the radiator out or (if there isn't enough clearance to lift it) lower it out the same way as the fan. Install the new radiator by reversing the process. Good luck.

There is no "low beam relay" in a 2007 Dodge Caliber. The headlamps (Hi and Low beams) are controlled by the Totally Integrated Power Module in the engine compartment.

Not sure,but look on drivers side below radiator.