SOURCE: water pump replacement in a 2002 Mazda MPV
The reason is the water pump is driven off the timing belt, extra parts and allot more labor. No the eng does not have to be removed, labor time around 4 hours, parts about, about $125 US for parts, if it is a dealer add $75 US
SOURCE: program remote control for mazda mpv 2002
Courtesy of: forums.mazdaworld.org
Try this, it works on several 2002 models:
Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the drivers door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT
- use ON position NOT ACC position). Do this 3 times within 10 seconds.
Leave key in the ignition.
Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a
final time with a series of door locks and unlocks. You're done
SOURCE: 2002mazda mpv the valves rattle alot when engine
They can be adjusted, though it is outside the range of the home mechanic. Most problems like this are caused by poor oiling. Your post says it is a 2002 model, which probably called for 5w20 or 5w30 oil. That is what you use for the first 100,000 miles or so. Next oil change, move up a grade on the oil, say to 10w30. You can also add a quart of Lucas oil stabilizer in place of a quart of oil. It helps alot. Hope this helps :)
SOURCE: Intake manifold runner control stuck closed?
you don't have to replaced the manifold just the runner control. see this all the time at work the part is about 175.00 and an hour and a half to install. your local dealer should be able to fix this for you
SOURCE: 2002 mazda mpv firing order please
let me know if this help you....
Testimonial: "tank you that was very helpfull because i call to mazda and they tell me the coil number 5 was in the midle on back "
Fig. Tighten the exhaust manifold bolts in 2 stages
To install:
308 views
Usually answered in minutes!
×