Drivers side door closed and will not open.

Check the linkage between the lock cylinder and the lock; when the latch was loose, the linkage may have broken or otherwise disconnected. The lock/unlock rod to the latch will be accessible inside the door for manual operation rather than using the lock cylinder or interior lock in the door panel. If this is the rear door on the driver side, additionally check the position of the child safety lock; when this is in the ON position, the inside door handle function is disabled. You can read more about door latch functions and how to replace them here: https://www.yourmechanic.com/article/how-to-repair-a-door-lock-actuator-by-marvin-sunderland

check and manually move linkage to unlock ---use a long screwdriver to move lock mechanism or if unlocked move latch to release

I am not familiar with this model but have experienced a similar nightmare on a very model. I suspect that the child safety locks are set which is stopping you opening the doors from the inside and the outside handles are not working because the latches may have been set in the locked position.

lube the latch up...
go to the passengers side and examine the latch... you could use a screwdriver and OPEN the latch on the drivers' door by pulling the door handle and prying the latch to the open possition... and try to close it ... repeate.

if you talking about door latch wont let door close.try to reset all door locks.first if you cant get door close.work unlock button with remote or door switch.then hold open door handle while you flat screw driver pull up latch in door latch should stay up so door will close.once get door close.try resetting all door locks by sitting inside vechicle with all doors close.remove key from ignition.open drivers door.wait 24 seconds.turn ignition switch on and back to lock position 3 times.press and release drivers door courtesy light 3 times.ensure doors lock and unlock.if not wait 40 seconds and repeat procedure.if this procedure fails. you have problem in the door latch and lock mechanism inside the door itself.

My friend just had this problem and he reached in and pulled the inside door handle back as far as it would go, and then let it go, allowing it to 'snap' back. For some reason this fixed it. We have no idea why. By doing this on one door, both rear door locks freed up and the rear locks are now working. Before, both rear locks were stuck and you could not open the doors from the inside nor the outside. Not sure why it works, but maybe it will work for you!

You can open up the inside panel of the door and adjust the tension in the cable that opens the door from the outside handle.

if you hit the lock button a couple times, will it finally lock?

If so, then you will need to take door cover off and lube up the connectors as they probably got corroded.

go inside, lift on handle, then beat the **** out of the door pounding it like your trapped in it trying to get out. latch mechanism is probably corroded and froze shut. once open, spray with wd40 and work the lever a lot. then get door panel off to see if handle is broken inside

Rear
Removal

1. Using a small screwdriver, remove the screw cover from the armrest of rear door trim panel (27406).
   

1. Remove the two retaining screws.
   

1. Using Trim Pad Removing Tool from Rotunda Windshield and Moulding/Trim Removal Kit 107-R0401 or equivalent, pry rear door trim panel from door inner panel.
   

1. Disconnect electrical connectors.
   

Installation

1. Position rear door trim panel on door inner panel, aligning two locators on rear door trim panel. Reverse Removal procedure.
   

------------------------------------------------------------------------------------ Rear
Removal

1. Remove door trim panel and watershield. Refer to Section 01-05 .
   

1. Check all connections of remote control links and cables. Service as necessary.
   

1. Remove remote control assembly.
   

1. Remove door latch remote control assembly from latch assembly.
   

1. Drill out rivet at bellcrank and link (264B14).
   

1. Remove three screws attaching latch assembly to door.
   

1. Drill out rivet that attaches actuator motor to door.
   

1. Remove latch assembly with actuator motor and door latch control rod lever link assembly.
   

Installation

1. Install new bushings and clip onto latch assembly.
   

1. Install latch with links and power lock actuator into door cavity.
   

1. Position latch assembly to door, aligning screw holes in latch and door. Install three screws. Tighten to 10-13 Nm (89-115 lb-in).
   

1. Attach door latch actuator motor to door with a new rivet.
   

1. Install bellcrank and link to door using a new rivet.
   

1. Install inside door handle and remote control assembly to door.
   

1. Open and close door to check latch assembly operation.
   

1. Install watershield and door trim panel. Refer to Section 01-05 .
   

Item Part Number Description 1 221A00 Door Handle to Door Latch Actuating Cable 2 26446 Rear Door Control Rod Retainer 3 377901 Plug Button 4 26412 Rear Door Latch 5 W623451-S2 Push Nut 6 224A32 Counter Balance 7 22450 Door Outside Handle Tension Spring 8 W701210-S309 Screw 9 224A20 Outside Door Handle Anti Rattle Pivot (2 Req'd) 10 22404 Door Handle 11 224A24 Front Door Outside Handle Spacer (2 Req'd) 12 264A64 Rear Door Actuating Rod 13 22408 Outside Door Handle Anti-Rattle Bumper 14 22428 Outside Door Handle Large Pad 15 N621906-S2 Nut (2 Req'd) 16 N807329 Screw (3 Req'd) 17 26595 Rear Door Electric Latch Actuator (RH) 18 W701566-S47 Rivet 19 431C04-A Rear Door Latch Striker Assembly 20 — Door Lock Striker Plate (Part of Door Shell Assy) 21 W525172-S Rivet (2 Req'd) 22 264B14 Bellcrank and Link (RH) 23 264A50 Bushing 24 N802034-SG Rivet 25 26420 Rear Door Latch Control Rod Link 26 W525172-S Rivet (2 Req'd) 27 21818 RR Door Latch (Inside) 28 A26460 RR Door Latch Push Button Rod 29 21982 Door Latch Rear Striker Assembly 30 N808377-S101 Screw (2 Req'd) 31 250A04 Rear Door Catch 32 N801010-S100 Truss Head Bolt (2 Req'd) 33 N804234-S2 Screw 34 266A74 Rear Door Latch Actuator Retainer 35 24630 Rear Door 36 26552 Rear Door Latch Control Escutcheon A — Tighten to 21-29 Nm (16-21 Lb-Ft) B — Tighten to 10-13 Nm (89-115 Lb-In) C — Tighten to 7-8 Nm (62-70 Lb-In) D — Tighten to 26-34 Nm (20-25 Lb-Ft) E — Tighten to 3-4 Nm (27-35 Lb-In)