I HAVE A 2003 HYUNDAI TIBURON WITH 1,6LITER ENGINE. HAVE BOUGHT A NEW 2006 2,7LITER ENGINE. CAN I USE TRANSMISSION, CLUTCH, DRIVE SHAFTS, STARTER FROM MY 1,6LITER ENGINE
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
My 2003 hyundai tiburon clutch and flywheel broke on 3 separate occasions since ...into reverse, I had a hard time finding it, it would not let me put it into reverse and I ....2006; Description of the Complaint: I have 2003 v6 tiburon, clutch failed at ... bought 2004 5 speed tiburon (she bought it before my problems started) and ...
hi their should be 10 bolts holding the head on and the tool you need is an inverted torque socket these are needed to undo the head bolts using an allen key would just thread the head and would mean drilling the head bolts out which is a night mare, so dont use allen keys as they will not be strong enough to undo the head bolts without threading the head bolts. as for the gearbox as long as you have undone the 2 at the top and the ones either side and the bottom bolt you should then be able to remove the gear box from the engine, the problem with your car is the gear box has not got much room to come away from the engine far enough to allow you to get it out, you may need to undo the engine mountin bolts to allow you to have a bit extra room you may also need an engine hoist to support the engine whilst removing the box, you may get away without one but it will be difficult.
make sure you have removed the drive shafts from the gear box and also the starter motor and make sure the speedo drive is undone and also the electrics for the reverse light if this is located at the top of the gear box.
The slave cylinder for your clutch has a valve in it, which keeps the clutch from engaging too quickly. The purpose is to keep you from just dumping the clutch and wreaking havoc on your transmission. If you're confident that you don't need that extra safety device in there, you can remove it, just google slave cylinder valve removal. It will give your clutch more of an aftermarket feel.
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
if you have a 4 cylinder you wiggle the clutch shaft up and down remove the lever and this will get the fingers off the releasbearing / 2 starter bolts 2 large bolts up top 3 under exhaust and 4 0n the other side lower one is above right inner cv axle, remove left axle from car right axle can moved over un do ball joint 3 mounts remover upper side and reaar , strap engine to a cradle or 4,4 post chained to support engine you can slide tranmission over14 inches with room to stick your hands in and remove pressure plate ,fly wheel can be removed but takes good hands tricky,now thats a hyundai flat rate tech procedure for 4 cyl, IF YOUR NOT SURE ABOUT or if the engine is V6 cylinder THE SUB FRAME COMES OUT you can remove rack hose on sub frame and 4 bolts and wire or strap the steering rack to body at that can stay in car or you will have to take rack out with sub frame
×