Check engine light on lost communication power train control module but runs great
DTC P0671: Cylinder #1 Glow Plug Control Circuit
DTC P0672: Cylinder #2 Glow Plug Control Circuit
DTC P0673: Cylinder #3 Glow Plug Control Circuit
DTC P0674: Cylinder #4 Glow Plug Control Circuit
DTC P0675: Cylinder #5 Glow Plug Control Circuit
DTC P0676: Cylinder #6 Glow Plug Control Circuit
DTC P0677: Cylinder #7 Glow Plug Control Circuit
DTC P0678: Cylinder #8 Glow Plug Control Circuit
Circuit/System Description
The glow plug controller has the ability to perform internal checks, an open or a short to ground on each of the glow plug circuits. If the glow plug controller senses a problem in a glow plug circuit, the glow plug on the affected cylinder will be disabled and the glow plug controller will send an error message to the engine control module (ECM). If this condition exists, the DTC will set.
Conditions for Setting the DTC
The glow plug controller detects that the glow plug control circuit is open, shorted to ground, or has more than 1 ohm of resistance.
Circuit/System Verification
Verify that DTC P064C is not set.
If DTC P064C is set, refer to DTC P064C.
Ignition ON, engine OFF, observe the scan tool Glow Plug 1-Glow Plug 8 parameters. All 8 Glow Plug parameters should closely match each other.
Refer to Testing for Intermittent Conditions and Poor Connections if you cannot duplicate the conditions.
Engine running, observe the DTC information with a scan tool. DTCs P0671-P0678 should not set.
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
DTC C0035 Left Front Wheel Speed Sensor Circuit
DTC C0201 Antilock Brake System (ABS) Enable Relay Contact Circuit
The system relay, located within the electronic brake control module (EBCM), supplies battery voltage to all of the valve solenoids and to the ABS pump motor. When the relay contacts close, the EBCM monitors the voltage supplied to the valve solenoids and compares this voltage to monitored ignition voltage.
797 views
Usually answered in minutes!
×