SOURCE: torque settings for bmw 316
hi for main bearings it is stage 1 : 25nm leave for 10 mins then stage 2 its turn 53 degrees for big end bearings it is stage 1 : 23nm leave for 10 mins then stage 2 its turn 70 degrees hope this helps
SOURCE: mitsubishi canter truck 4d34 torque settings
Hi!!!
Most manuals I found do not cover diesel engines. There is a Peter Russek manual for your truck which covers diesel engines. Click on the following link to check the manual
http://www.auto-repair-manuals.com/Mitsubishi-1997-2002-L200-2WD-4WD-2-0L_2-4L-Petrol-2-5L-Diesel-Russek-Repair-Manual.html
THIS ARE THE SPECS FOR A 04 MITSUBISHI LANCER.
Identifying Fastener Tightening Specifications Table
ITEMS SPECIFICATIONS
Roll stopper bracket mounting bolt69 ± 10 N.m (51 ± 7 ft-lb)
Shift cable bracket mounting bolt19 ± 3 N.m (14 ± 2 ft-lb)
Select lever mounting bolt19 ± 3 N.m (14 ± 2 ft-lb)
Speedometer gear mounting bolt4.0 ± 1.0 N.m (35 ± 9 in-lb)
Backup light switch32 ± 2 N.m (24 ± 1 ft-lb)
Interlock plate bolt30 ± 3 N.m (22 ± 2 ft-lb)
Poppet spring32 ± 2 N.m (24 ± 1 ft-lb)
Control housing mounting bolt19 ± 3 N.m (14 ± 2 ft-lb)
Under cover mounting bolt7.0 ± 1.0 N.m (61 ± 9 in-lb)
Reverse idler gear shaft mounting bolt48 ± 6 N.m (35 ± 4 ft-lb)
Clutch housing-transaxle case mounting bolt44 ± 5 N.m (33 ± 4 ft-lb)
Front bearing retainer mounting bolt19 ± 3 N.m (14 ± 2 ft-lb)
Select lever mounting nut12 ± 1 N.m (104 ± 9 in-lb)
Stopper bracket mounting bolt22.3 ± 0.3 N.m (16.1 ± 0.2 ft-lb)
Clutch release bearing retainer mounting bolt9.8 ± 2 N.m (87 ± 17 in-lb)
Differential drive gear mounting bolt132 ± 5 N.m (98 ± 4 ft-lb)
SOURCE: does anyone know the crank main bearing nut torque Alfa V6 3l
Torque to 25Nm, then tighten through a further 79 degrees. You need an angle gauge to do it properly.
2,253 views
Usually answered in minutes!
×