My passenger air bag light goes on intermittently. I am wondering when that happens if the driver air bag would still work if there is a crash.
Hello Collette,
(Owner Manual Page 2-68)
The passenger sensing system turns off the right front
passenger frontal airbag and seat-mounted side
impact airbag under certain conditions. The driver
airbags and the roof-rail airbags are not affected by the
passenger sensing system.
The passenger sensing system works with sensors that
are part of the right front passenger seat. The sensors
are designed to detect the presence of a properly-seated
occupant and determine if the right front passenger
frontal airbag and seat-mounted side impact airbag
should be enabled (may inflate) or not.
I'm not sure if a purse or other light weight objects would activate the passenger airbag but if your display is showing random passenger activation it would be best to have a qualified dealer check into it...better safe than sorry.
http://www.gm.ca/media/owners/manuals/2010_Chevrolet_Malibu_Manual_en_CA.pdf
SOURCE: Passenger Air Bag Warning light stays son
is this van new for you ? is it a status light letting you know that the airbag is loaded and ready for anypassenger that you have in your van ? do you have a key that you can turn it off in most vans there is an option to turn air bag on or off depending on size or opinion of passenger . im thinking that if its a status light its okay to be on letting you know its ready for opperation . take a look at your owners manual airbag section . and if it does turn out to be a warning malfunction indicator please dont waste time take it to your local dealer and have it checked out .hope this information helps good luck
SOURCE: the airbag light came on and stayed on for no reason.
I have the same issue (which comes and goes often).
It is caused by a loose wire connection, used for the drivers side airbag located in the seat.. The connector for mine is located under the front drivers seat. There are a couple of connectors that are connected to a bar under the front of the seat. I don't recall which one is used for the Airbag sensor.
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
SOURCE: chevy silverado 2006 lights "service air bag"
First of all you need to get this problem fixed ASAP. While the airbag light is illuminated, your SDM (Sensing and Diagnostic Module aka: the brain of your airbag system) shuts of power to the airbags. In which, if you are in an accident your airbags will not deploy while this light is illuminated. You need to take your vehicle to a GM dealership. A Tech 2 scantool is needed to retrieve the code from the SDM. Hopefully it won't be a costly repair, but is something that defineatly needs to be corrected soon. Good luck and hope all works well.
Testimonial: "very fast and helpful, thanks"
SOURCE: air bag light wont go off after cycling 04 chevy express
YOUR VEHICLE HAS DETECTED A FAULT IN THE AIRBAG CIRCUIT IT WILL HAVE TO HAVE CODE RETRIEVAL DONE TO DETERMINE WHAT CAUSE LIGHT TO STAY ON,I URGE YOU TO DO THIS SOON AS WHEN AN AIRBAG SYSTEM HAS GIVEN A FAULT CODE AND TURNED ON THE LIGHT THE SYSTEM IS DIABLED AND WILL NOT PROVIDE PROTECTION IN ACCIDENT
Testimonial: "I tried what you suggested, and it worked the light cycled an went out thanks , david"
12=Low Battery Voltage
13= Air Bag Circuit Shorted to Ground
14=Primary Crash Sensor Circuit Shorted to Ground
21=Safing Sensor Not Mounted to Properly
22=Safing Sensor Output Shorted to Battery Voltage
23=Safing Sensor Circuit Input Feed/Return Circuit Open
24=Safing Sensor Output Feed/Return Circuit Open
32=Driver Side Air Bag Circuit High Resistance or Open
33=Passenger Side Air Bag Circuit High Resistance or Open
34=Driver Side Air Bag Circuit Low Resistance or Shorted
35=Passenger Side Air Bag Circuit Low Resistance or Shorted
41=RH Primary Crash Sensor Feed/Return Circuit Open
42=LH Primary Crash Sensor Feed/Return Circuit Open
44=RH Primary Crash Sensor Not Mounted to Vehicle Properly
45=LH Primary Crash Sensor Not Mounted to Vehicle Properly
51=Air Bag Diagnostic Monitor Internal Thermal FuseFuse Blown Due to Intermittent Short to Ground
52=Backup SupplyVoltage Boost Fault
53=Primary Crash Sensor Circuits Resistance to Ground or Air Bag Diagnostic Fault
Hope this helps...
456 views
Usually answered in minutes!
×