If all other functions of the seat are working then you're more than likely either looking at a bad switch, wiring to it or the motor is bad, if the tilt uses the same motor as the up and down or back and forth, then it's probably the switch.
SOURCE: Jeep Grand Cherokee Limited Power Seat Problem
Replacement parts and labor could run $200 + from the dealer.. Yes, a replacement switch can be obtained from a salvage yard, BUT NOT from an auto parts store. It is not difficult to remove old switch and replace
SOURCE: I have no low beams on my 2009 Acadia. Fuses are
could be two blown bulbs or the control switch
SOURCE: The tilting switch on my
It could be a faulty switch it won't be a blown fuse or wiring issue (its too protected). Most likely it is a faulty tilt motor in the underside of the seat frame. There are 3 seperate motors, and I have replaced all three at different times.
SOURCE: The headrest in a 2009 gmc acadia will not stay up when the seat is in the upright position
Pull it up end down , it should lock in to position ,when it hits a slot on the shaft, If not there is something broke on the locking mechinissim
SOURCE: driver power seat adjustment and steering tilt not
I had the same problem, the c and s class seem to have the issue with the power seat and steering wheel adjustments. On my 04 it was two bare wires under the drivers seat that were touching and blowing the fuse (fyi)
1,199 views
Usually answered in minutes!
×