Question about Jensen Cars & Trucks

Open Question

What all does the bypass code do for the jensen unit

Its a jensen vx4022

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2011 ram big horn 4x4 automatic indicator won't go to drive function. Goes to 4.engine light scans a po882 and po883 code. Tipm problem reset to fix?


codes refer to transmission control module problems === causes wiring --poor connections ---short to ground -- wiring short to positive - TCM
check the condition of the wires at the box and the connections for loose, water and corrosion , then replace the TCM unit

Sep 10, 2016 | Dodge Ram Cars & Trucks

1 Answer

How do i bypass antitheft system in my 2004 nissan titan


"Try checking your battery and or starter. If not them you might have another electrical problem. , have the gas cap tested or just replace it, then disconnect the battery for 5 minutes to reset the code, then drive it for a few miles and see if problem comes back, if it does a trip to the dealer is in order, as this may be covered by your emission warranty which is good for 70,000 miles. , if you are talking about the factory unit(transponder in key)you CANNOT bypass (its in the ecm) if its an aftermarket/dealer fit unit,you may want to take the whole unit out,but be warned some do not come out without totally messing up the car.

Sep 27, 2015 | Nissan Cars & Trucks

1 Answer

After market stereo in 1997 eddie bower ford expodition provides no sound


You should be using line out from your aftermarket stereo if using the vehicle's existing amp. Then again, you may choose to bypass it, depending on the power being put out by your new stereo.
In both the Expedition and Excursion, the sound systems are different than smaller Fords. The Eddie Bauer typically had the Premium sound system, and the wiring can get tricky with those. You want to make sure it's done right so you don't short out and damage the amp circuit in your new stereo.
If all you're using is the existing speakers, then go ahead and bypass.

Feb 14, 2012 | Jensen Cars & Trucks

1 Answer

Amp color code wire diagram 2002 tahoe


I just built a factory amplifier/crossover bypass adapter for my 2002 Chevy Tahoe Z71 (non-Bose system) . This adapter will allow the full range of audio directly from your head unit to the door speakers. Without this adapter, the factory amplifier will cut out much of the bass / low frequency audio to the door speakers. This adapter will continue to provide an audio signal to the factory amplifier for the rear factory subwoofer and cargo area pillar speakers.


I have posted an article with complete set of step-by-step instructions and detailed photos of the build and installation process.

http://www.savagehomeautomation.com



The article also includes direct links to the exact parts that I purchased on Amazon to build this bypass adapter.


This is what the end result looks like. It is a 100% non-destructive adapter than can be installed or removed from the Tahoe at any time. It just plugs in between the factory wiring harness and the factory amplifier.7_9_2012_1_38_07_pm.png

Good Luck!

Feb 01, 2012 | Cars & Trucks

1 Answer

Replacing the air conditioning unit with a bypass pulley. where do i start?


Why do you want to bypass it? Is the unit froze up? If not, try unplugging the unit form the electrical source. It should still turn but not kick in unless the compressor is froze.

Dec 05, 2011 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

HOW DO I BYPASS MY 97 JETTA ANTITHEFT SYSTEM?


if you are talking about the factory unit(transponder in key)you CANNOT bypass(its in the ecm)if its an aftermarket/dealer fit unit,you may want to take the whole unit out,but be warned some do not come out without totally f...... the car.

Jun 20, 2010 | 1998 Volkswagen Jetta

1 Answer

How do you bypass the ac unit on a 98 Chevy Blazer?


Go to your local parts store. Ask them for a AC bypass pully. You will remove your AC pump and replace it with the pully and bracket. hope this helps.

May 20, 2010 | 1996 Audi A4

2 Answers

2004 Taurus: i want to bypass the a/c unit...


get new sepentine belt #795k6 from advance auto parts also belt tensioner tool route belt exactly the same just omit the a/c unit this will work

May 18, 2010 | 2004 Ford Taurus

1 Answer

2000 Pontiac Grand Am -- Security light/Passlock -- Engine turns over but won't start & the security light flashes. This has happened twice in the last 3 months. Do anyone know if this type of problem...


there is a way to bypass the system we do it often but you will need to buy a data bypass unit to install in order to bypass the passlock sensor in the dash. Once the unit is installed, it is turned on by inserting the key into ignition, then the unit will send the proper code to the BCM allowing it to unlock the ECM and then car will start.

Aug 30, 2009 | 2000 Pontiac Grand Am GT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jensen Experts

john h

Level 3 Expert

20284 Answers

Dan Hooper
Dan Hooper

Level 3 Expert

3210 Answers

Robert Wesighan
Robert Wesighan

Level 1 Expert

6 Answers

Are you a Jensen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...