If the system is empty, it will usually hold about 1 1/2 to 1 3/4 gallons of liquid. You can add water, but you want to make sure it is distilled water. you do not want to use tap water as the minerals will clog up your system causing more expensive future repairs. But you also do not want straight water as the boiling and freezing points are not optimal. Your best bet is to use premixed universal coolant.
2.2 engine 10.3 quarts the 2.4 engine 10.7 quarts the following link is the owners manual for the 96 sunfire and page 6-58 has the capacities for the whole vehivle
1996 Pontiac Sunfire Owner Manual
SOURCE: 98 Pontiac Sunfire 2.2l Reading engine codes
you need a OBD-II code reader or take it to autozone they do it free
SOURCE: 2001 Pontiac Sunfire 2.2 L overheating / runs out of antifreeze
it could be one of three things: drive belt, water pump or thermastat when you take in for the flush have all of these checked out
SOURCE: adding transmission fluid to 98 pontiac sunfire
There is a plug located on top of the transmission under the brake master cylinder. It is held in place by a bolt on the side of the transmission near the firewall. Remove the bolt, then remove the plug. Fill it until the fluid comes out of the hole.
SOURCE: serpentine belt diagram for a 1996 pontiac sunfire.
email me at [email protected] and i will send you the diagram
SOURCE: rear brake diagram for 1996 pontiac sunfire
take both drums off the do one whilst looking at the other in case you forget where that little spring went
138 views
Usually answered in minutes!
×