2001 Nissan Xterra Logo

Related Topics:

Tony Lee Graves Posted on Jul 03, 2016
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

2001 nissan xterra drivers front door glass replacement

Broke the drivers side front door glass and was wondering if there is a manual or step by step instructions available here. thanks

1 Answer

Jason Martin

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 249 Answers
  • Posted on Jul 03, 2016
Jason Martin
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Jan 25, 2013
Answers
249
Questions
0
Helped
46044
Points
637

First get a new glass on the way, then YouTube window installation for your type of vehicle, seeing how window regulators are replaced might give you a partial idea towards replacement.
Best of luck!

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Can I super glue the outside side view mirror on my Xterra?

Clean both the bases and use silicone to stick the glass to the base and tape it for few hours and you will be fine.
2helpful
1answer

I have a 2000 Nissan Xterra with 2 error codes: PO325 and PO303. What needs to be repaired/replaced?

P0325 knock sensor 1 circuit malfunction bank 1 or 1 sensor, the knock sensor should be check/replaced. You can buy Haynes Repair Manuals at Pepboys that will walk you throught the process step by step.
P0303 is a cylinder misfire in cylinder 3 which may mean it could either be the spark plug, coil or the injector.
1helpful
2answers

How do I replace the window regulator on my Sentra

you need to raise your window 1st take out nuts holding window regulator manually raise the glass and hold the glass by using tape motor and reail or regulator they come in one piece i beleive/make sure you disconnect the power going to the motor before you take it out
3helpful
1answer

How hard is it to replace valve cover gaskets on a 2001 Nissan Xterra? looks like the passenger side would be easier than the driver side.

if this is your first have someone with you in is a job and must be done correct way or you will have big proplems
2helpful
2answers

Front bumper on my 2001 xterra is rusting. I want to remove it , sand it and repaint. How do I remove the front bumper?

Grab a factory service manual it will make it much easier, plus you may need to remove other parts as well. Here is link to a factory service manual for your 2001 Nissan Xterra.

0helpful
1answer

Left front drivers side power window went down but left glass up then glass fell down to bottom of door. I took door panel off and was able to push glass up but cannot get it on its tract or even see the...

Hello and thank you for using FixYa!

Most likely your window regulator cable broke. That is why the glass can not be controlled. You will need to remove it and inspect it to verify.

Thanks Jay!
0helpful
1answer

Replace driver side mirror on 2001 Nissan Quest

SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the upper speaker.
    1. Disconnect the electrical connector.
    1. Remove the bolts.
    1. Remove the speaker.
  1. Position the watershield aside.
  1. Remove the exterior rear view mirror access panel.
  1. Disconnect the exterior rear view mirror electrical connectors.
    • Release the wiring harness locator.
  1. Remove the exterior rear view mirror.
    • Remove the bolts.
    • Feed the wiring harness through the door opening.
0helpful
1answer

Electric window motors

They should be the Same Motors.
0helpful
1answer

Passenger side mirror wiring harness nissan xterra

take your door panel off slowly and unplug your mirror from inside the door
Not finding what you are looking for?

83 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...