Does everthing still work , engine runs, fuel guage reads etc ? if so this wire may not be required , most vehicle manufacturers will use the same wiring looms on many different models, so some wires/connectors may not be required on every vehicle
The fuel level shows car still want crank
do you mean engine doesn't turn over or doesn't fire up ? could be something other than fuel pump
The man that worked on it kept telling us to buy lots of stuff we didn't need. Admitted to never installing a fuel pump. Installed a new one today and it wouldn't crank
its difficult to say for definate without being with vehicle , what was the initial problem ? sorry but need to start at the begining of the problem with your vehicle, so a short description of what was first problem would be very helpful
Went to get gas. The gas light had been on for a lil while. Turned the car off put gas in. It never started again.
i would think its more to do with the fuel lines or injectors being blocked as ran low on fuel , the other thing that can happen is the ECU hasn't registered the fuel in the tank and thinks it is still low and is stopping engine starting , have you had the OBD read , this may have a code saved that needs clearing , hope this helps
I tried having the obd code read by two different people first one says system error the other says no link. What does that mean?
i would think you need to take vehicle to a nissan approved dealer , as these 2 OBD code readings can only be cleared by nissan approved equipment , as is most likely to be a problem of the ECU communicating with the rest of the vehicle sensors, switch's etc hope this helps
×
SOURCE: 87 Nissan pickup
Check the distributer cap and rotor for cracks and make sure the rotor shaft bushings are not worn out
SOURCE: Do you know where or if a 2000 Mazda 626 has a
Hello, I am going to make a few assumptions here. The vehicle has an electric fuel pump and you replaced it. The vehicle has fuel injection. The engine is actually cranking, just not starting, when you say "car still won't crank". You are getting fire to the spark plugs at the plug ends. You checked the fuel pump for power at the pump. No power, then you back traced the wire to the fuse block and checked the fuse to see if it was blown. If the fuse is good back trace the power to the ignition switch and/or ECM for power. You have power at the pump, check the ground and make sure it is connected properly. Will the pump run when someone turns the key on? Pump runs, check fuel manifold for pressure. No pressure, check the fuel filter for blockage, or replace it. Fuel pump doesn't run, new replacement pump is defective. There is usually some type of control module for the fuel pump on fuel injected vehicles. Good Luck, RAC
SOURCE: 2001 Chevrolet Impala 3.8 fuel pump wiring diagram
The wires should be grey, orange and black, purple, and a black wire. The purple goes to purple, grey to gray. The orange and black goes to the small black wire on your car harness and the black goes to the bigger black.
SOURCE: 94 dodge ram 1500 5.2 replaced fuel pump still no
U NEED TO CHECK THE FUEL PUMP AND AURO SHUT DOWN RELAY.THEY ARE IN THE UNDERHOOD FUES & RELAY CENTER.U CAN SWITCH THEM 1 AT A TIME WITH A/C RELAY.IF THAT DOES NOT WORK U MAY HAVE A PROBLEM WITH THE PCM
100 views
Usually answered in minutes!
×