How to change a low fuel light on a 2003 Mazda 6

SOURCE: Loud acceleration noise in my 2003 Mazda 6 2.0 auto

one thing to check is rear engine mounting i have had a stone wedged in one and it causes a nasty noise when accelerating

SOURCE: changing a wheel bearing, 2003 mazda 6

to change that, using a hydraulic press is highly recommended. if you are DIY experienced, this trick works as well:

take a pice of a stable metal pipe, 10-20 cm long. and in diameter just a tick smaller than gross bearing size. take a very heavy tool and use the pipe to beat out the old bearing. dont be shy, needs a lot of power.

do not use this method to insert the new bearing. use a pice of wood instead (must sit stable on the outer bearing ring!!), lubircate a bit and beat carfully and very straigt in fractions of a mm. this is the difficult part and here the bearing may brake if you are too rough.

Not really recommend, but working when used with brain and care.

SOURCE: mazda 6 2001, IBS and handbrake warning lights keeps coming on

Check brake fluid level.  If fluid level is low, it can cause lights to flicker on and off while driving.

SOURCE: Remove 2003 MAzda 6 parking light bulb

http://forum.mazda6club.com/electrical/135367-changing-194s-headlights.html

SOURCE: 2005 mazda 6 V-6 3.0

hi try checking the relays the 1 for the low beam may be faulty