Opened the car door last night and no interior dome lights came on. I pushed the keyless remote to activate the headlights and dash lights, they worked, but no dome lights worked? First time this ever happened. I will check the fuses later, anything else to look for? 2002 Bonneville

Dash lights (Gone?) - FSB Forums - FullSizeBronco.com

www.fullsizebronco.com/forum/21.../198643-dash-lights-gone.html

Sep 7, 2011 - Fully rotating the shaft counterclockwise past a notch activates theinterior lights within the vehicles. ... No aftermarket stereo, the dash lights stopped working, and my taillights ... 8 15 Courtesy/Dome/Cargo Lamps, Electric Outside Mirrors, ... 12 20 C.B. Power Door Locks, Electronic Shift Motor 4WD, Power ...

Radio died, remote system not working, door locks will not work ...

www.topix.com > Chrysler Sebring

Aug 13, 2008 - So what all is not working at this time is: Door locks (with remote it only ... My lights on the dash dim some times and if I hit a bump the radio goes off, ... All the fuses are good, but still no power to the radio, interior lights, push ...

2009 Chrysler Town and Country No Dash instrument cluster lights ...

forum.chryslerminivan.net/.../55281-2009-Chrysler-Town-and-Country-...

Jan 13, 2014 - 10 posts - ‎5 authors

Courtesy Lights
The courtesy lights come on under the following conditions:
?€¢
Any door is opened.

?€¢
The interior lamp switch is in the ON position.

?€¢
The keyless entry transmitter unlocks the doors (illuminated entry).

When the key is removed from the ignition switch with all of the doors closed, the courtesy lights light for approximately 25 seconds before fading out.
Battery positive voltage (B+) is applied at all times through the IP fuse block CTSY LP/PWR MIR fuse 6A via CKT 640 (ORN) through the body control module (MALL) to the courtesy lights via CKT 1732 (ORN). The MALL provides a ground through CKT 156 (WHT) for the courtesy lights under the following conditions:
?€¢
The MALL receives an input from a door being opened.

?€¢
The MALL receives an input from the interior lamp being turned ON.

?€¢
The MALL receives an input from the doors being unlocked using the keyless entry transmitter.

The courtesy lamps then light.
When the courtesy lights are activated by opening and closing a door, the courtesy lights will remain on for approximately 25 seconds before fading out after all of the doors are closed. If the ignition switch is turned to START or RUN within the 25 seconds, the lights immediately begin to fade out. If a door is left open, the MALL removes battery positive voltage (B+) to the courtesy lights after 10 minutes. When the courtesy lights are activated by the interior lamp switch, the lights remain on as long as the interior lamp switch is in the ON position. When the courtesy lights are activated by unlocking the doors using the keyless entry transmitter, the lights remain on for approximately 40 seconds. If the doors are locked using the keyless entry transmitter within the 40 seconds, the lights immediately begin to fade out.
Body Control Module (MALL) Diagnostic Mode
For a detailed explanation of the MALL module diagnostic mode, refer to Body Control Module Cell 51.
What interior light ? Dome , courtesy lights etc....They don't work with switch, keyless entry , door opening ?
What

These are activated by little push in switches located on the door frame. When you close the door, it pushed the pin switch in and disconnects the power from the inside lights. You should also check the light switch on the dash. There is a setting on the headlight switch usually that allows you to turn on the inside dome lights by that switch. It may be in that position and will keep your inside lights on until the switch is returned back to the normal position.

its either a bad door switch,or could be the dome override switch by headlight switch,or your interior light switch is all the way up

There should be a button inside the door arch, on the hinged side, that activates the interior lights when the door is opened, this button also turns the light off when the door is closed.
Find this button and push / activate it manually with your hand.
If the light is not turning on and off, check that the switch on the interior dome light is in the "DOOR" position, not the OFF or ON position. this is usually the middle position.
Check all the Auto door light buttons on all doors, you may find one that is loose (not springing back into position) this will need replacing as it could be the cause of the interiour light on working automaticly.
I hope some of this helps

check for a dome light on and off switch by the headlight switch or check to see if the dash light dimmer is not turned down the whole way. if those are good then check to see if the door switch by the hinge is not stuck

Does the van have remote keyless entry (RKE) system ?
Interior Lighting System Description
Vehicles with the optional remote keyless entry (RKE) system have interior lighting controlled by the body control module (BCM).
This vehicle uses a delayed interior lighting system.
The system functions as follows:
• The dome lamps will illuminate when any door is opened.
• The dome lamps will remain on for 20 seconds after the last door is closed.
• The delay is canceled and the dome lamps will go out when the ignition switch is turned to the ON position.
• The illuminated entry function will not operate when the dome lamp defeat switch is in the OFF position.
• The interior lighting system is protected from battery rundown by the retained accessory power (RAP) system. The RAP system functions by shutting down interior lights after 10 minutes (when ignition is OFF).

Interior Lights Circuit Description
When the interior lamps circuits are closed/enabled, the courtesy lamp relay is activated by the two following coil circuits:
• CKT 690 (GRY/BLK) which is the courtesy lamp enable output of the body control module (BCM) driving the coil side of the relay.
• CKT 1732 (ORN) which is the coil output side of the relay going to the potential grounding switches/sources.
When the courtesy lamp relay is enabled, CKT 156 (WHT) (courtesy lamp output) is enabled by the closed contact at the relay and then grounded by CKT 750 (BLK) at G110.
Some of these circuits can also be activated with the headlamp and panel dimmer switch. When this happens, the coil output side of the inadvertent power relay is grounded to the body control module (BCM) via CKT 1393 (DK BLU)
CKT 40 (ORN) from the courtesy fuse drives both input sides of the inadvertent power relay. When the contact is pulled closed, CKT 1732 (ORN) is supplied power, thus driving any lamps/circuits attached that circuit and providing ground.
The body control module (BCM) also monitors the following four door inputs:
• CKT 49 (DK BLU) -- LH door jamb switch input
• CKT 54 (ORN) -- RH door jamb switch input
• CKT 775 (PNK) -- Side door jamb switch input
• CKT 656 (YEL) -- Rear door jamb switch input/liftgate strut switch input (depending on option content)
When the doors are closed, the body control module (BCM) is in a floating state of 0-2 volts. When the doors are opened, the courtesy lamp relay is activated, sending power to the courtesy lamps.
The headlamp and panel dimmer switch also activates the following interior courtesy lamps when the switch is placed in the PARK or HEADLAMP ON positions:
• RF power window switch
• RH power door lock switch
• LH power window switch
• LH power door lock switch
• LH outside rearview mirror control switch
• Rear radio control head
The dome lamps can be disabled by closing the dome lamp defeat switch located on the headlamp and panel dimmer switch.

--------------------------------------------------------------------------------
Courtesy or Dome Lamps Inoperative
Step
Action
Value(s)
Yes
No
Important: Verify functional bulbs before beginning diagnostic procedure.
1
Did you perform the Lighting Diagnostic System Check?
--
YES - Go to Step 2
NO - Go to Diagnostic System Check - Lighting Systems
2
Are all of the courtesy/dome lamps inoperative?
--
YES - Go to Step 6
NO - Go to Step 3
3
Activate courtesy/dome lamps
With DMM, check for battery voltage from inoperative lamp CKT 1732 (ORN) to ground
Is battery voltage present?
B+
YES - Go to Step 4
NO - Go to Step 5
4
Repair open in CKT 156 (WHT) between inoperative lamp assemply and S214.
Is the repair complete?
--
NO - Go to Step 10
--
5
Repair open in CKT 1732 (ORN) between inoperative lamp assemply and one of the following splices:
• S258
• S301
Is the repair complete?
--
Go to Step 10
--
6
Turn the courtesy lamp switch to the ON position
Check for battery voltage at BCM C2 cavity B12.
Is battery voltage present?
B+
Go to Step 7
Go to Diagnostic System Check - Body Control System in Body Control Systems
7
Verify continuity of the following three circuits with DMM:
• CKT 1732 (ORN) between courtesy lamp relay and body control module
• CKT 156 (WHT) between courtesy lamp relay and S214
• CKT 750 (BLK) between courtesy lamp relay and S206
Are all of the circuits functional?
--
Go to Step 8
Go to Step 9
8
Replace courtesy lamp relay.
Is repair complete?
--
Go to Step 10
--
9
Repair the inoperative circuit.
Is the repair complete?
--
Go to Step 10
--
10
Operate the system in order to verify the repair.
Did you correct the condition?
--
System OK
Go to Step 2

I am not real sure about this but my 2001 Blazer has this option. Right by the headlight switch is a button called the dome over-ride and if this is activated the interior domes will not work. Try that and if this is not the case let me know and I will look farther into it.

Lefty64

" turn the key on engine off 8 times. the doors will lock and unlock. push one of the buttons on the key fob and the doors will lock and unlock. do this for each remote that you have. when you are done turn the key off. the door locks will lock and unlock. the remote fob should work after this."
From My SecuriLock..