How to change left side headlight

Mercury Sable - YouTube

? 6:06
www.youtube.com/watch?v=Mlb1V5vNgFM
Jan 3, 2012 - Uploaded by 1A Auto Parts http://www.1aauto.com/1A/HeadLights/Mercury/Sable/1ALHP00223 ... Find out why. Close. How to Install Replace Headlight and Bulb Mercury Sable 00-05 ... How To Install Replace Fog Lightand Bulb 00-03 Mercury Sable

adjustment is on the top of the light and the side.

sounds like partial short in headlight switch

lights left side 06 muatang dont work

Take out 1bolt just above headlight that holds headlight in place.Then to the left of headlight there is a 6inch pin you have to turn clockwise 1/4 turn then pull up and out.Remove headlight,ther is enough wire to put it to the side while you change the left turn signal.When the headlight is out of the way you can see the wires for the turn signal,turn the plug counter clockwise and pull,you will see lightbulb,pull out and change.To install do the reverse in order.

Changing front, right turn signal on 2005 Buick Terraza: Open hood; when facing the front of vehicle, the right turn signal is on the passenger side (left). The headlight assembly needs to be removed to easily reach the turn signal. On my vehicle, there is a 10 mm screw on the left side. Remove it. There is L-shaped pin on the right side of the headlight assembly. Swing the pin counter-clockwise (to the left). Pull the pin straight up to remove. The headlight assembly is now loose, but there is a pin snapped in a socket on the back of the assembly that still holds the assembly. Pull the headlight assembly hard and straight to the front of the vehicle. When it snaps loose, the assembly is now held just by the rubber gasket surrounding the assembly. You need to gently work the right side of the gasket out of the grill cowling. The assembly should pull straight out. The wires are long enough to lay the headlight assembly in the engine compartment. Finally, the turn signal is now accessible. Twist the light holder counter-clockwise and pull out the light holder. Change the bulb. Do not punch your man-card for credit until you have successfully reinstalled the headlight assembly. It goes back in a little easier the second time. Once you have put the L-pin in place, the screw back, and successfully tested the lights, you can now punch your man-card.

I give the mechanical engineers and designers a D-minus instead of an F only because I was successful on the first try. No light bulb on anything commonly used by people should be this hard to figure out.

It might be hard to get to like that. You will see a silver metal bar with a 90 degree angle at the top that goes straight down behing the headlight assembly, which you can pull up on. It holds the headlight in. Once you pull this up pust the headlight slightly sideways as there is a plug holding the headlight in at the back, then just pull forward to give youself space to work. Clip off the two clips and slide the back cover off then you can change the bulb out.

Reach beind the headlight and just unscrew the cap that holds it in. However don't touch the new bulb with your bare fingers or you will drastically shorten the life of the bulb.

go here. we can help you. Also, did you check the headlamp relay in the box under the hood? One relay is in box in front of battery, other is in narrow box along passenger side fender under the hood. swap left & rt headlamp relays to see if it changes.

http://groups.yahoo.com/group/villagerquest/

i think there are two flat guide pins that hold the headlight assembly in .. just pull them straight up ..and the assembly should come out ..hencse replace the bulbs.