Hi Rafa, The link below is a web site showing fault codes, Just scroll down the list......... CHEERS..
P1493 RCNT Solenoid Circuit Malfunction
Complete List of OBD Codes Generic OBD2 OBDII Manufacturer Car OBD...
SOURCE: How many O2 sensors on a 1997 Lexus ES 300?
according to the manual i have... it has three.... one in the exhaust manifold.... and two in the exhaust pipe..... slightly vauge on the exact location of the last two sensors... but looks like it is after the catylitic converter.
SOURCE: Lexus ES 300
Unscrew the gas cap, wait 30 sec and screw it back on making 3 clicks/cracks. Should be ok in a day or two.
SOURCE: location of fuel filter on 2000 lexus es 300
The fuel filter on the ES300 is located under the hood, on the driver's side, by the fenderwell.
SOURCE: where is the starter located on the car 1999 lexus es 300
Change 1999 Lexus RX 300 Starter
Here are some steps:
1. Disconnect the positive and negative cables from the battery.
Disconnect the 2 bolts that connect the battery hold down bracket to
the vehicle. All of that was done with a 10 mm socket. Remove the
battery it and the plastic tray that it sits on from the vehicle.
2. Loosen the large clamp that secures the engine air intake to
the big black plastic box that houses the air filter with a 10 mm
socket or a large phillips screwdriver.
3. Unplug the large electrical connector from the top of the
air filter box by pressing the tab on the plastic connector and
pulling. Unplug the small electrical connector from that same box top
in the same manner. This 2nd plug plus a small black air hose the size
of your finger are just below and to the left of the master cylinder
when you are looking at the engine from the front. Squeeze the hose
clamp with plyers and remove that small hose also.
4. Remove the top of the air filter box and the air filter.
5. Remove 3 10 mm bolts from the bottom of the now empty air
filter box and pull the box out of the vehicle to gain access to the
starter.
6. Depress the tab on the small wire connection that is
attached to the starter and pull the wire out in the direction of where
the battery had been. This tab was hard to find and press and I ended
up getting a mirror to be able to see the tab and what needed to be
depressed. I pressed from the bottom up and then pulled the connector
out to my right.
7. Remove the 2 starter bolts that hold it to the engine block with a 14mm socket.
8. The starter was snug but you should be able to pull it out
(to your right) and flip it up so that the starter gear is pointing
towards you to have access to the large cable that is hooked to the
starter for power.
9. Use 2 small screwdrivers to slip under the snaps on the plastic connector cover. Open it and slide it back down the cable.
10. Using a 12mm socket, remove the power cable from the starter.
11. Reverse this process to put the new starter in.
12. Enjoy the praise that your wife gives you for a job well done!
Good luck, and remember rated this help.
Testimonial: "very helpfull thank you for your support keep up the good work.you all or life savor. [email protected]"
SOURCE: Where is the location of the fuse box for the
Here are two picture diagrams, one is to locate the fuse box it sits above your left knee, you may have to remove a cover to get to,i labeled a couple of fuses to check theres the cigarette lighter fuse, if thats not blown then check the other two, if it is blown then disregaurd the other one, hope this is what you were looking for.
238 views
Usually answered in minutes!
×