1998 Chevrolet Tahoe Logo
robert hunt Posted on May 07, 2016

Window lock switch wont disengage. Also, all of the sudden none of the power locks work. Any ideas?

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

M drivers window goes up and down beautifully, but none of the other windows work. They just all of a sudden stopped working? HELP!

Check the child safety locks on the rear doors and check the master window lock switch on the drivers door. If that switch is active then the window controls on the other doors are deactivated.
0helpful
2answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere

First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

1helpful
1answer

Power windows and power locks wont work

Check your fuses first. Then check for power at the switches, and power from the switches to the respective solenoid and motor. Most likely it's fuses. Also check where the wiring runs through the door into the car for bare spots in the wiring that might have blown the fuses.
0helpful
3answers

Drivers side window wont work and power locks dont work ,mirror works, passenger window works

I have the exact same problem. Fuses look good, I have no idea what the problem is?
5helpful
1answer

How to remove the inside door panel from a dodge 2005 2500 pick up

FRONT DOOR TRIM PANEL - REMOVAL
Release door latch and open door.
Roll window down.
Remove window crank Window Crank - Typical , if equipped.
Remove screws attaching trim panel to door Door Trim Panel and Trim Panel Screw
CAUTION: Do not forcibly pull trim panel from door, damage to trim panel may occur.

Simultaneously lift upward and outward to release retainer steps from inner door panel Trim Panel Retainer
Disengage inside handle linkage rod from inside handle.
Disconnect speaker harness wire connector Speaker And Power Mirror Connector
Disengage power mirror wire connector, if equipped (driver's side only) Speaker And Power Mirror Connector
Disengage clips attaching power window/lock switch panel to door trim panel. Disengage wire connector from switch panel, if equipped Power Door Lock/Window Connector
Separate door trim panel from vehicle.
INSTALLATION
Position trim panel at door.
Engage wire connector for window/lock switch panel, if equipped. Engage clips attaching power window/lock switch panel to door trim panel.
Engage power mirror wire connector, if equipped.
Connect speaker harness wire connector.
Engage inside handle linkage rod to inside handle.
Align trim panel retainer steps with inner door panel and slide trim panel into place.
Install screws attaching trim panel to door.
Install window crank, if equipped.

Hope helped with this; remember rated this help. Good luck.
0helpful
1answer

Windows/Roof

if it has a window lock switch then that is where i would look next. also look at your fuses
0helpful
1answer

Ford Expedition 2001 that wont shift out of Park

Shift Interlock System
The shift interlock system prevents the shifting from PARK unless the brake pedal (2455) is depressed. The shift interlock system consists of a shift lock actuator (3Z719) mounted at the base of the steering column tube (3514). If the ignition switch (11572) is in the RUN position, the shift lock actuator is continually on unless the brake pedal is depressed.

Thier is also the shift lock actuator ! plus wiring . You have a short to ground on that circuit . Do you know how to Find a short ? videos on youtube .
None of the power windows work ? Check for broken wires inside the rubber boot from the body to drivers door !
Videos on youtube for testing power window circuits .
How to test power window switch motor 1985 2001 Toyota
3helpful
3answers

2001 Chevrolet Impala Door Locks Suddenly Quit Working

Passenger side of the fender under the hood - check the fuse relay box - about $12.00 a piece - they do go bad from time to time.
exchange the power lock relay with another one and test the locks.
then put the relay back and go to the autostore.
7helpful
2answers

C. differential lock not working

pressed the c diff lock by accident - now the alarm wont go off when I turn it off? What should I do?
Not finding what you are looking for?

129 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...