1.4 Durateq 7T engine code
First you need to know the diameter of the bolts and the type of thread ie 3/8 N/C or 5/16 N/F then look at the type of bolt ie plain steel or high tensile SAE grade 3, 4, or 6, once you know this go to a general purpose bolt torque chart, and derive the torque spec info.
If the engine block is cast iron use the full torque specification.
If the engine block is alloy then reduce the torque spec 10%
Below is an example of a general purpose bolt / nut torque chart
SOURCE: main and rod bearing torque specs
do you have a Haynes Manual or Chilton? if not check your local library, they may have one, the specs are in there
SOURCE: need bigend torque settings for a Ford Ranger 3.4
need more info as to what your working on heads block etc
SOURCE: i need to know the torque settings for 850cc reliant robin
go to
http://mankymonkeymotors.co.uk/Trikespageimages/relianttorquesettings.html
a target="_new" href="http://www.leafletflyers.co.uk/">Leaflet Distribution in Croydon</a>, Leaflet Distribution in Balham, <a target="_new" href="http://leafletflyers.co.uk/Leaflet-Distribution-Streatham.htm">Leaflet Distribution Streatham</a>.
SOURCE: I am looking 4 the
mains - vertical bolts first 30 ft.lb. PLUS 90 degrees
pattern frt
8 7
4 3
2 1
6 5
10 9
side bolts 22 ft. lb plus 90 degrees
pattern frt
7 8
3 4
1 2
5 6
9 10
connecting rod caps cracked type rod-rod and caps must be kept in matched sets, recommend new bolts/nuts, spec is 32 ft lb. plus 105 degrees - torque each item to the correct torque then go back and do the degrees. these are torque to yield bolts and the procedure is very important.
SOURCE: 1999 ford focus rear wheel
WHEEL BEARING LARGE HUB NUT TORQUE 232 FT LBS.
Testimonial: "thanks for your help"
1,829 views
Usually answered in minutes!
×