How to replace outside side power mirrors in original housing? 2008 Ford Edge

The related help links are mentioned below.Click the link below:---
---------How to remove rear view mirror metal foot?

http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-rear-view-mirror-metal.html

----------

power locks, power window and power mirror on the passenger side not working on Ford Windstar
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html

----How to Remove Outside Mirrors on Acura Integra?

http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-outside-mirrors-on-acura.html

-------Passenger side Folding Mirror is not operating? http://schematicsdiagram.blogspot.com/2011/12/passenger-side-folding-mirror-is-not.html

--------
These will help.
Thanks.

This is how the glass shops in my area do it. Clean all the glass out of the mirror carefully. Don't want stitchs. Clean all the old glue off with a knife or razor blade and wash it with window cleaner. Wash the back of the new mirror as well with window cleaner. Put a liberal coat of silicone adhesive on the back of the new mirror and press it into place. Place a small block of wood or plastic on the mirror face and tape it on with black electrical tape. Stretch the tape as you wrap it around, make about 2 complete wraps. Do this on the inside and outside of the new mirror and leave it for 24 hours. Then you simply remove the tape and blocks and nobody will know the difference. Hope this helps. You could also get a auto glass shop to do it. It's not especially expensive. Hope this helps.

- Adjust the mirror so the mirror glass is in as far as it will go (meaning if you were looking in the mirror you would see the side of the truck)

- Look inside the mirror housing
- Locate silver clip
- Using a flat screw driver, push the clip in
- Lenses will pop out on the outside
- Remove bulb
- Replace bulb
- Snap back together when new bulb in place.

- Adjust the mirror so the mirror glass is in as far as it will go (meaning if you were looking in the mirror you would see the side of the truck)

- Look inside the mirror housing
- Locate silver clip
- Using a flat screw driver, push the clip in
- Lenses will pop out on the outside
- Remove bulb
- Replace bulb
- Snap back together when new bulb in place.

- Adjust the mirror so the mirror glass is in as far as it will go (meaning if you were looking in the mirror you would see the side of the truck)

- Look inside the mirror housing
- Locate silver clip
- Using a flat screw driver, push the clip in
- Lenses will pop out on the outside
- Remove bulb
- Replace bulb
- Snap back together when new bulb in place.

Could be screwed on from inside the door and might have to remove inner door panel for access. OR there may be some screws on the outside - if nada maybe the cover can be carefully pried off to expose the screws. If you google this I am sure you will find something re how to. Just be careful since you do not want to damage the paint job on door.

I checked Ford Focus mirror replacement and it seems to be the same. This is for the manual, unheated mirror.

Remove the mirror cover inside the door - slide a screwdriver behind the cover and pry loose carefully.

Remove the single 10mm bolt and the mirror comes free.
NB. Do not drop the bolt into the door.

I'm pretty sure the light is part of the glass. The mirror glass is available seperately. Check Ebay or tascafordparts.com for a discounted part. Or, car-part.com for used one. Page with * is lowest price.

here is 2003 Nav. I don't have 2004. May be similar. please give good rating if this help. Good luck
-----
Removal and Installation

1. Position the mirror glass to obtain a gap at the top edge of the mirror and carefully pull the top edge of the glass away from the mirror housing.

1. Disconnect the heated mirror electrical connectors.

1. Remove the exterior mirror motor screws and exterior mirror motor.
   • Disconnect the electrical connectors.

1. To install, reverse the removal procedure.

-------

If you are facing the passenger side mirror adjust the top (large) mirror so that it is turning in towards the truck as far as it will go. Then look behind the mirror in the bottom righthand corner (outside bottom corner) and you will see a silver metal clip. Take a straight head screw driver and push on that clip and the lens will pop out. Then you simply unscrew the bulb holder from the lens and replace your bulb. Good luck!