It wont shift into overdrive the transmission has pressure I changed to fluids when I go to pass it wont shift into overdrive

The erratic jumping in and out of overdrive (O/D) on your 2006 Terrano 3GMR with a 3.2L engine could be caused by a few different issues. Here are some possible causes and fixes:

1. Faulty speed sensor: The speed sensor provides input to the transmission control module (TCM) to determine when to engage overdrive. A faulty sensor can cause the TCM to think the vehicle is going too slow or too fast for overdrive engagement. A mechanic can test the speed sensor and replace it if necessary.
2. Low transmission fluid level: Low transmission fluid level can cause the transmission to shift erratically or not engage overdrive. Check the transmission fluid level and add fluid as necessary. If the fluid level is low, it's important to also check for any leaks that may be causing the fluid loss.
3. Worn or damaged overdrive band: The overdrive band is responsible for engaging and disengaging overdrive. If the band is worn or damaged, it may not engage properly. A mechanic can inspect the overdrive band and replace it if necessary.
4. Transmission control module (TCM) issues: The TCM controls the shifting and engagement of overdrive. If the TCM is malfunctioning, it may not engage overdrive or cause erratic shifting. A mechanic can test the TCM and replace it if necessary.

It's recommended to have a professional mechanic diagnose and repair the issue, as the transmission is a complex and vital component of the vehicle.

smell the trans fluid if it stinks its time to change, change the filter and do a pressure flush to make sure all bad fluid is gone.

low fliud pressure in transmission..check levels and change fluid/filter and retry vehicle.

Kinda sounds like it works when fluid is thick and not after it warms up. If it has been awhile since trans fluid and filter were changed it is the most simple thing to change. The torque converter is a big pump, it may be going and not providing enough pressure. This could be checked on most transmissions by a shop expert. Sometimes pressure can be adjusted externally.

For Automatic transmission problem,click the link below:----Overdrive light in the dash blinks? http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html
--------- Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
Transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

SOUND PROBLEM IN TRANSMISSION OIL PUMP OR TRANSMISSION TORQUE CONVERTER.SINCE YOU NEED BOTH OF THEM EITHER ONE MALFUNCTION THERE WILL BE NO LOW DRIVE GEAR OR OVER DRIVE.MAKE SURE TRANSMISSION FLUID LEVEL NOT LOW. IF ALL LOOKS GOOD. YOU CAN CHANGE TRANSMISSION FLUID AND CHANGE FILTER FIRST TO SEE IF HELPS ANY. IF NOT TAKE TRANSMISSION TO SHOP.THEY NEED TO RUN OIL PUMP PRESSURE TEST TO SEE IF OIL PUMP BAD.

I'm afraid that the transmission's O/D solenoid malfunctioning or kick down cable may be misadjusted if so equipped.

looking at a rebuilt transmission if you plan to keep the Caravan.

Or, alternatively, could get a low mileage transmission from a salvage yard and have it installed.

----
Servos/Accumulators The servos are hydraulic pistons and cylinders. They resemble the hydraulic actuators used on many other machines, such as bulldozers. Hydraulic fluid enters the cylinder, under pressure, and forces the piston to move to engage the band or clutches.
Servo operation

The accumulators are used to cushion the engagement of the servos. The transmission fluid must pass through the accumulator on the way to the servo. The accumulator housing contains a thin piston, which is sprung away from the discharge passage of the accumulator. When fluid passes through the accumulator on the way to the servo, it must move the piston against spring pressure, and this action smoothes out the action of the servo.
Hydraulic Control System The hydraulic pressure used to operate the servos comes from the main transmission oil pump. This fluid is channeled to the various servos through the shift valves. There is generally a manual shift valve, which is operated by the transmission selector lever, and a shift valve for each up shift the transmission provides.
Most automatic transmissions are electronically controlled; electrical solenoids are used to control the hydraulic fluid. The shift solenoids are regulated by an electronic control module. Shift timing is regulated through sensor feedback information provided to the electronic controller.
On older transmissions there are two pressures that control the shift valves. One is the governor pressure which is affected by vehicle speed. The other is the modulator pressure which is affected by intake manifold vacuum or throttle position. Governor pressure rises with an increase in vehicle speed, and modulator pressure rises as the throttle is opened wider. By responding to these two pressures, the shift valves cause the up shift points to be delayed with increased throttle opening to make the best use of the engine's power output.
Older transmissions also make use of an auxiliary circuit for downshifting. This circuit may be actuated by the throttle linkage, vacuum that actuates the modulator, or by a cable or solenoid. It applies pressure to the downshift surface on the shift valve or valves.
The transmission modulator also governs the line pressure, used to actuate the servos. In this way, the clutches and bands will be actuated with a force matching the torque output of the engine.

Greetings Idpeters:
Please check your transmission fluid level. After the engine is warm pull the transmission stick and make sure the level is close to the full line and that the transmission fluid is red and not brown. You may have to change your transmission fluid and screen. If you plan to do it yourself I can advise you on how to change it step by step or you can take it to a transmission shop or dealership for a transmission tune-up. Good Luck

the trans is toast, most likely an internal fluid pressure seal has failed.

Have you ever changed the transmission fluid flush and replaced the transmission filter?