Check engine light, vsc, and slip indicator light came on. Pulled codes and it said to replace coils and so we replaced all six, including putting new spark plugs. The check engine light went away but the other two lights are still on. They will go off when you turn the car off but when you start it and put it in gear and move just a little bit they come right back on.
What were the code numbers you gave me code c1336 This means there is a zero point calibration code unfone. So you need a zero point calibration needs to be reset with a scan tool.
The code we pulled is C1336.
×
SOURCE: Warning lights on a 2006 toyota rav 4 32,000 miles
I had the same problem. A computer check showed that the emission system was having difficulty. The catalytic converter had to be replaced. The car had under 80,000 miles on it so it was covered by a warranty (State law? Federal law?).
My battery was also dead. That was replaced free too. It had a 7 year warranty.
I do NOT purchase extended warranties.
SOURCE: Check engine light comes on and the transmission shifts rough.
There is a tsb on this and the fix is to change the engine contrl
ol modul if the code is p2716. There is nothing wrong with the solenoid....the problem is the sender to the solenoid.
SOURCE: 2004 Toyota 4Runner, Regarding The VSC TRAC and VSC OFF lights
Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.
SOURCE: 99 Toyota Corolla multiple misfire problem
This is what you need to do, change the plug wires, because if there is a bad wire you would definitely experiences sputter or a stutter, so do the plug wires and at the same time do the spark plugs, this should take care of your problem. if not let me know and i will give you the next step
Testimonial: "So far the car is working fine after I replaced the spark plugs and wires! Thanks so much!"
1,473 views
Usually answered in minutes!
×