-
Ford Master
2,993 Answers
- Posted on Jul 16, 2009
Re: Replace right rear break light
PLEASE DON'T FORGET TO RATE!!!
Signal & Marker Lights
Removal & Installation
Rear Lamp Assembly Sedan
To Remove:
- Before servicing the vehicle, refer to the precautions in the beginning of this section.
- Remove the luggage compartment quarter trim panels.
- Disconnect the rear lamp assembly electrical connector.
- Remove the lamp assembly mounting nuts.
- Pull the lamp assembly away from the body.
- Disconnect the rear lamp assembly bulb connectors.
- Remove the rear lamp assembly.
To Install:
CAUTION
To prevent water from entering the luggage compartment, make sure the rubber grommet is fully seated.
- Position the rear lamp assembly near the body and connect the bulb connectors.
- Install the lamp assembly into the body.
- Install the lamp assembly mounting nuts. Tighten to 53 in-lbs (6 Nm).
- Connect the rear lamp assembly electrical connector.
- Install the luggage compartment quarter trim panels.
×