Which is the color and position of the daewoo lanos 2001 camshaft wiring circuit

code p0342 refers to camshaft position sensor(CMP) sensor A bank 1 --low input== causes wiring short to ground--CMP sensor--ECM
check wiring and connections , replace the position sensor

• P0342 Camshaft Position Sensor Circuit Low Input P0122 Code - Throttle Position Sensor/Switch A Circuit Low Inputith a P0442, the most common repair is to: Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap (we recommend an OEM not aftermarket part), or Inspect the EVAP system for cuts/holes in tubes/hoses
• A code P0122 may mean that one or more of the following has happened: TPS not mounted securely TPS circuit short to ground or another wire Faulty TPS Damaged computer (PCM

black is ground, red is hot, yellow is memory,blue is activation wire for amps or antena ,speakers are green ,gray and white ,and purple negetive and positive wires to each of those colors .

its on the back cam under the timing belt cover on the one i done last week with a timing belt change

hallo
P0342 code means: camshaft position sensor- low imput. Check wiring (short to earth), if OK change camshaft position sensor.
Marko

on single cam engine its inlet manifold side just behind cam gear rear cover bolted into cam box cover
twin cam its behind cams in middle front of engine in centre of rocker cover remove cover over h.t.leads this one is eazy but tricky due to bolt inside cam belt cover

its a crank sensor no signal p0337.good luck,i hope this help pls dont forget to rate me thanks

DTC 63 Will Set When
No voltage is supplied by the ECM through the EST “B” line while reference pulses are received by the ECM from the crankshaft position sensor
check white wire terminal B on ignition coil to ECM terminal C14 for open circuit or short to ground while disconnected if thats ok check for voltage signal at B while cranking no signal ECU faulty. voltage signal also on A terminal while cranking and check earth terminal C to body no higher than 5 Ohms
power is terminal D 12V
if getting power, earths good, and both signal voltages are going into coil pack, coil pack is faulty.

hi,
it is under the upper timing belt cover between the camshaft gears. According to the manual touching anything related to timing belt requires removing million parts including right front wheel. I suspect this might be an overkill just to remove upper timing belt cover.

So my advice would be to get it done by some mechanic as u will not be able to do it and may damage other parts also.

Thanks!
Sandy

when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car