Diagram purge valve 2003 Hyundai Tiburon 2.0 - Hyundai Cars & Trucks

Question edited for clarity.
Question moved to model category.

2003 Hyundai Tiburon Car Radio Wiring Chart - MODIFIEDLIFE

MODIFIEDLIFE https://www.modifiedlife.com > 2003-hyundai-tiburon...
Our 2003 Hyundai Tiburon radio wiring diagram shows you all the radio wire colors and what they do. Table of Contents. 2003 Hyundai Tiburon Radio Wiring Diagram ...

Hyundai Tiburon 2003-06 - Scosche

Scosche https://www.scosche.com > media > guides PDF AMPLIFIER LOCATIONS: VEHICLE MAYBE EQUIPPED WITH FACTORY AMP. LOCATED ON DRIVER SIDE PANEL ON FRONT OF REAR. SPEAKER. W ...

I need the wiring diagram for a infinity model h285jcbl 2003 car radio and amp

There is only 4 vacuum lines on that engine

1- brake booster line

2- purge line to purge solenoid (top center of throttle body)

3- PCV hose. run straight from PCV to side of intake at base of throttle body

4- fuel pressure regulator line (short small diameter hose runs from #6 intake runner to fuel pressure regulator

5- tube that connects front cam cover to rear cam cover to improve vapor venting

http://www.hyundai-forums.com/attachments/gk-tiburon-coupe-s111-2003-2008/38204d1276396353-vacuum-lines-2004-tiberon-pict0001.jpg

All Hyundai engines are 'interferrence' engines, meaning valve clearance is less than '0' if valve timeing is off by more than 30 degrees.

On your Tiburon the purge valve is located below the throttle body. It is easier to access if you remove the boot between the airbox and the throttle body. After removing the boot look under the throttle body, the purge valve will be found mounted in a rubber hangar and it has a vacuum hose to both ends.

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:


And the 2.7 Liter V6:

is this what your looking for??
Front Door Glass:

this code refers to EVAP Emission Control System Incorrect Purge Flow, it can be tricky to diagnose because of the number of parts, I would first check the vacuum hoses between the purge valve and the air cleaner, then the purge valve and the canister, also check the fuel tank vent and fuel cap valve and gasket. any one of these can cause this check engine code. after checking this I would reset the computer and see if it comes back.

factory fitted alarm?? no way its done through the ECU and shuts down the spark via the processor and try finding a wiring diagram??